Header banner
Revain logoHome Page
autohaux pinion flange holding holder logo

AUTOHAUX Pinion Flange Holding Holder Review

2

·

Average

Revainrating 3.5 out of 5  
Rating 
3.7
🚗 Transmission & Drive Train, 🛠️ Replacement Parts

View on AmazonView on ЯM

Media

(4)
img 1 attached to AUTOHAUX Pinion Flange Holding Holder
img 2 attached to AUTOHAUX Pinion Flange Holding Holder
img 3 attached to AUTOHAUX Pinion Flange Holding Holder
img 4 attached to AUTOHAUX Pinion Flange Holding Holder

Details

ColorCopper Tone
BrandX AUTOHAUX
MaterialAlloy Steel
Item Package Quantity1

Description of AUTOHAUX Pinion Flange Holding Holder

for Jeep Ring Rear End Axle Nut, for Ford IRS and straight, for Chrysler, for General Motors, for Toyota. Please refer to the detailed scope of application Fitment. Made of quality solid 3 / 8 "thick steel.It can be firmly fixed in the required position without bending. When removing or installing the nut, the pinion yoke or can be fixed in place. Perform ring and pinion installation or just replace and upgrade your and yoke. Replace the leaking pinion seal or gasket. Wrench Diameter: 143mm/5.63"; Thickness: 9.5mm/ 3/8"; Fixing Tool Size: 95x16mm/ 3.74"x0.63" (L*W); Max.Width: 32mm/1.26"; Hole Size: 8mm/0.31"; Thread Size: M11x1.25. Package Included: 1 x Fixing Tool, 1 x Drawing Tool Plates.

Reviews

Global ratings 2
  • 5
    1
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 5 out of 5

Stable and reliable holding holder

The AUTOHAUX Pinion Flange Holding Holder is a must-have for those who work with transmission and drive trains. Based on our own experience, it is highly stable and reliable ensuring that the pinion flange is held properly in place during repairs and maintenance. The holder is made of durable materials that are able to withstand heavy use and it is also easy to install .However, the holder may not be compatible with all vehicle models out there, so make sure to check before purchasing..

Pros
  • Stable and reliable
Cons
  • May not be compatible with all vehicle models

Revainrating 1 out of 5

Not hardened steel. Garbage.

The concept is great. The square holes for the crowbar are already too big. Combine that with the torque you need to apply to tighten the gear and you're left with rounded square holes. The steel plate is not hardened and will not withstand the work. Shop elsewhere.

Pros
  • Transmission and transmission
Cons
  • Some defects