🔌 AUTOPA Rear Left Power Window Regulator with Motor & Panel Assembly for Dodge Nitro 2007-2011 Review

After realizing it was pretty close to OEM, it only took 5 hours to install. The hole in the window doesn't look like the white part with the key that fits in that hole.

Attaching the glass to the lifter is difficult, ensure you use the pre-drilled hole to slide the lifter under the glass to secure it. Learned this the hard way.

PERFECT FIT‼️‼️ I did this for this SPECIFIC VEHICLE for the first time but my son and I managed, we figured out how to unplug the connectors and Clips removed that took us forever also had no fit problems because they were perfect and not flimsy at all and looked just like the original. I hope that the engine and all mechanisms will last a long time. To push the window, do it through the speaker hole because the rear window doesn't go all the way down in this car

The panel appears to fit well but is otherwise cheaply made and the window retaining piece broke trying to install it. I had to use part of the original fairing as a replacement, assemble the fairing and reinstall it. Lost a lot of time. A few years ago I had to do this with a different door on this car and I used a different supplier. Dorman: I think so, and it was a much better experience. It was a little less money and shipped early so I took a chance. Do yourself a favor, pay the extra $10…

well the part worked but only after using the original window holder (I had to replace the old window holder with a new one) because when I tried to press the window the holder didn't fit and the whole mechanism fell apart. I had to take the whole thing apart again and rewind the cable system onto the spindle and replace the old plastic window holder which had better guidance and easier insertion of the window into the holder. The actual piece of plastic that everything is built on is cheap and