🔪 BOSCH T234X Progressor Wood Blade (5-Pack): Upgrade Your Cutting Efficiency! Review

These blades are great. I tested them right away by splicing two 1/2 inch pine boards together and trying to cut a thin line at the same time and these blades held up great and made a nice curved cut. Nice improvement over the blades that came with my PORTER-CABLE PC600JS 6A orbital jigsaw. Fits perfectly and works great.

I bought my first jigsaw to make an extra 2cc box. which blade was the right one. After trial and error and testing several other brands versus Bosch, Bosch emerged victorious for cutting ability and edge retention. I stumbled across this blade while reading this article and can safely say that it will remain my go-to blade for clean cuts in MDF and plywood and will likely extend to less detailed scrolling work as well.

These blades are probably the best I've ever used. I recently bought a Revain Dewalt 18v jigsaw and a set of Dewalt blades that came with it. I thought they did a good job, but only good; and I thought they didn't match the overall capabilities of the saw itself. Looking around I found that someone else with the same puzzle had recommended these canvases. I'm confident and glad I have them! They cut quickly, accurately and accurately. They produce an almost "polished" cut surface and require…

They cut fairly cleanly but not so well at spiral cuts. However if you want something quick to cut these are very cheap for the price I found them for. When Bosch calls it "clean," that's what you use if you don't want to do a lot of sanding afterwards. If it's marked as "Progressor" it means you need to make two parts instead of one as soon as possible. There are many positive reviews about the new Xtra Clean T308B blades. I'll check them out when my first set arrives. However, it is difficult

The 5/8" bamboo deck I've used it with outperforms the hardest wood by 4500 Janka (I've had a lot of issues with the brackets bouncing off the wood during installation). quicker (but not fast) and with less effort than other canvases, with nice clean edges.On my cheap jigsaw!Made it a new tool.Even the bamboo worked with the underbody with no problem when I needed to trim some HVAC vent work .No cheap chinese junk here - I could get lost looking at the design, how the blades are cut.Good job…

I need to cut 5/8 thick MDF melamine boards for my craft business. I have tried many blades and different TPIs (teeth per inch). and after trying several brands and different types i finally have this blade in my box of different blades from BOSCH. and BINGO. It was the best wood so far. I'm an elderly woman and don't have the strength to push a manual jigsaw and I really needed a blade that got the job done and easily slid through wood and this blade did it with no effort. The cleanest cut was