Bosch TS1008 Left Support Table Review

Well designed and fairly strong, this support should adequately support most of the wood you may wish to cut. This installation problem has less to do with the item itself and more to do with the holes in the bottom of the table to which it is designed to attach. On my table, the coating they applied to the table covered the holes so much I had to run a faucet down the holes to get the screws in. The required faucet is 6Mx1.0 and the empty faucet will work adequately. There isn't enough room to

This is honestly essential to fully utilizing the 4100 saw I'm not sure why they couldn't just hook it up to the saw. So I bought it. There is no doubt. To sum up my installation experience: I spent 10 minutes assembling and an hour trying to get this damn thing to move smoothly without sticking. Too many variables. You have two tubes on the bottom of the saw (slotted) that should be perfectly parallel. GREAT. Otherwise the foils will stick together. I'm a mechanical engineer from a good school

I bought this left side support TS1008 for Bosch GTS1041A-09 REAXX table saw which comes with a similar rear support. Pros: * It works exactly as you would expect. - Provides left side support for sawing wider pieces of wood. Just a little wider, not "very wide".* It was easy to install, contrary to what other reviewers have described here. Tip: Tighten by hand and then adjust. Cons: * The rear mount blocks 10" discs from the disc storage on the REAXX table saw. You can still access tools to…