🔧 10-1220 Winch Mount Plate Bracket Kit for Polaris RZR XP 1000 RZR900 2014-2018 General 1000 2016-2018 (Model A) Review

Guide plate was too narrow for existing 1/4" bolt holes. After bending the plate they will do. Bolt holes for Warn winch 4500# did not match, had to drill new holes.

Looks good. The winch plate fits perfectly. The front panel had to be bent to fit the front A-arm studs, after which holes were drilled. Overall, with an extra hour of work, it does what I need

This is a very basic product that fits my 2019 4 seater RZR piece. You don't have to remove anything. I only shared it on the passenger side. Both tops put the winch on the driver's side no problem

I used this bracket to install a Badland XRS 35OO winch on my 2021 General. It had to be routed so that it would not interfere with the front differential vent. After laying and tightening, it works perfectly. I would recommend this mount.

Well made and good quality. NO INSTRUCTIONS! Check your tube and a little mechanical skill can be adjusted. The front headlight grille assembly MUST be removed to gain access to the tie rod bolts to allow the cable reel to attach to the plate which is bolted to the studs. A solid 1.5 hours to install.

I installed a winch mount and it fits but needs 12 spacer washers. The supplied screws are designed for different applications, which makes assembly difficult. The guide plate mounting holes are not the same as the 2019 RZR XP 1000. I will cut and weld to make it work. It's easier than removing and reinstalling the winch mount.

Although the metal is thick and well made, it's cheap Chinese junk. There are no installation instructions. The exposed powder coating of the fairlead bracket was scratched. It is clear that it was either delivered earlier or thrown away. There was also no fortification. A complete waste of money and time waiting for the goods. Don't waste money on a brand. Buy a well-known brand.

This was an incredibly easy install. But the fairlead mounting holes do not match the RZ's bolt mounting points. I had to cut it so that one of the holes in the plate was open on the end to access both bolts on the RZR. Either the main plate was changed or the bolts weren't long enough because 2 of the 4 were short and probably barely reached the nylon lock bolts.