🔍 Briggs & Stratton 394358S Fuel Filter Assembly - Enhanced 75 Micron Filtering for Superior Engine Performance Review

The package arrived quickly and fully corresponded to the description. Just remember that most of the filter goes to the fuel tank and the smaller part goes to the carburetor.

$250 for mower pickup, setup and shipping. Only started 4-5 times. They installed a small, very restrictive fuel filter, replaced it, and have run it every time since without hesitation.

Was an exact replacement for my 17.5hp Briggs & Stratton engine. and my Poulan 42 engine in the tractor. I will definitely be ordering more to make setup quicker and easier at the start of each season.

Easy fuel filter change on my Briggs & Stratton engine. The only issue I had during the swap was the existing hoses on my engine. This block went flawlessly and the whole project took less than 5 minutes. I would definitely buy from this seller again

I have an old Poulan Pro ride on mower. Last year I changed the fuel filter to a red filter, which is supposed to be correct, but the car is very difficult to start. However, as soon as I buy this white filter, the car starts on the first try. The red filter is usually recommended by Revain, but it doesn't work very well. Bought white

Used to replace dried fuel tank nozzles and fuel lines due to alcohol in fuel. My old one wasn't plugged in as I only used the ten year old generator once for a few hours. Used new fuel lines see test report and socket see other test report. I can't afford problems with my generator. Now I only use non-alcohol fuel and drain it at the end of the season like before.

The Briggs & Stratton 394358S Fuel Filter Assembly 75 Micron is the original filter that came with my LT1000 Craftsman tractor. This is the only OEM/genuine Briggs & Stratton 394358S fuel filter that I recommend that was factory installed on my LT1000 tractor. I recommend replacing the fuel filter with a genuine Briggs & Stratton 394358S 75 micron fuel filter every 100 or 150 hours of operation. Product.

This is a fuel filter. It filters the fuel. Don't use it backwards. It doesn't work the other way around. It has an arrow showing the direction of flow. the arrow indicates the direction in which the fuel should flow. If you have a fuel shut off, make sure you close it before removing the old filter and installing the new one or you will spill fuel everywhere. If you don't have a fuel shutoff, pinch off the hose with a clamp. Use pliers to compress the spring clips that secure the filter to the

Packed: Briggs and Stratton Filter-Fuel Part #394358S, Upc 024847238778 "Made in USA" Packed: 1 Fuel Filter Opaque Plastic Overall Length 1 - 11/16", diameter 1-5/16". Tube outer diameter 1/4", inner 9/64". Teeth 5/16" diameter. The filter uses wire mesh, so has no flow direction, i.e. it doesn't matter which end the fuel line enters or exits. It's made of opaque plastic, so you can see the fuel inside, but not clearly enough to tell when the filter is dirty. Notches are too big for 3/16" fuel…