Clyxgs Water Cooling Radiator: 8 Pipe Aluminum 💦 Heat Exchanger with Fan for PC CPU Water Cool System Review

I didn't buy this cooler for a computer but for a cooling bath for a condenser column. This thing is a beast, it chills the tub to the point where I don't need to add ice to it anymore. Another thing I have to worry about for my burner is less.

This is great for grain washing and cooling. The fan isn't great, I had to replace it after about 20 minutes, but the heatsink is sturdy and doesn't leak. I bought a better fan and maybe the old one failed because I didn't tune it properly, but it works great for my purposes and I would buy it again for the heatsink alone.

I used this for a peltier cooler project at home. All in all it works well and is worth the money. I ended up updating the fans. Took my coolant from 105f to 95f at 70f ambient temp. I don't know the actual flow rate, but my flow meter is spinning fast

works great with 2 in a 4x8 room for basement cooling on a glycol chiller and fan controller. It takes some ingenuity to make a bracket to attach them to. It would be nice if they came with something or even grommets you could screw them to.

Before installing the cooler I tested fans with a 12 volt wall: one fan did not spin at all, the other spun very slowly for 10 seconds before stopping. Returned and bought another "brand" with no fans. (They are probably all made by the same company in China.)

I use a CNC spindle to hold the temperature, the fan is quiet, a 50/50 mix of water and antifreeze goes through just fine. No leaks found.

I used this product for water cooling circuit and phone cooling. I was concerned that the water cooling circuit I created for my phone and laptop wouldn't cool down as it was 80mm not 120mm when I put heavy loads on it e.g. B. when playing. However, I was amazed when not only did it keep temperatures down on my phone and laptop, but it was almost silent when I was using it and cost less than half the price of a noctua heatsink/fan combo.

I made a small personal fridge out of a vacuum insulated stainless steel bottle. I put a 5v submersible micropump in the bottle, connected it through the cap to the heat exchanger and then back into the bottle. When filled with ice water, I can get cool breeze for about 1.5 hours. The heat exchanger works perfectly.