🔌 Cmple 2 Port Keystone Wall Plate Single-Gang Ivory - 10 Pack: High-Quality Standard Size Keystone Jack Insert Review

Be sure to file the network connector clip before installation. Otherwise, unplugging is a real problem, especially since it's difficult to get fingers and a screwdriver between all the other jacks. The hob works perfectly.

My Cat 5e and Cat 6 jacks are ideal for Keystone. There is a small lip on one side of the jack and a large locking clip on the opposite side. They were most easily inserted if I first inserted the small lip and then twisted the large clamp. The nests are firmly held in place but can still be removed.

As mentioned by others this wall plate does not exactly fit (at least some) low voltage mounting plates including the following: https://www. amazon.com/gp/product/B0791CXM3W/ref=ppx_yo_dt_b_asin_title_o03_s01?ie=UTF8&psc=1 . In addition, the paint on the screws wears off very quickly.

Not a cheap piece of plastic - actually nice, thick and strong. Be aware of how much space you need, especially with a coaxial connector that needs a lot of free space. I installed my panel on a 1" deep junction box and barely had enough room to mount the coax cable. Networking was ok,

I am adding extra outlets to my house and bought these CMPLE Keystone outlets. I have old hard plastic jacks and ivory network plates and wanted to customize them. This is a hard ABS but the ivory color does NOT match the traditional ivory color for my other outlets. These plates are more of an almond brown color. See photos of purchased trapezoidal sheets on the left, my old sockets and another trapezoidal socket on the right. These plates are not made of ivory.

I would give these 5 stars but subtract one star because out of the box they do not fit into commonly available "old" sockets (due to interference between the reinforcement around the screw holes and the box lugs). ). There is also a slight interference between the inside curved edge of the exhaust panel and the lugs on the exhaust boxes. A small knife and/or grinder or grinder on the lid and box solves the problem, allowing the pad to fit snugly against the wall.

Ordered Ivory but they were much darker than Electrician's Ivory. The color also varied between each in the package I received. The paint on the screws comes off very easily exposing the silver underneath. They also started adding screws with small plastic tabs to the back of the panel - these tabs don't make the panel flush with the wall - it hits the side of low voltage junction boxes (tried 3 different brands of boxes). different designs.) Had to cut the tabs off and they fit better but…

I bought 20 of these based on another review which found them to be a perfect Leviton plate replacement and compatible with Leviton Quickport bushings. Unfortunately they didn't succeed. The bushing holes are *close* to the correct dimensions. The openings are slightly smaller vertically (width is ok). I ended up having to cut about 1mm of material from the top of each hole to fit the Leviton bushings. In the end it took a very long time and used up all the savings I was hoping for by choosing…