🔄 Enhanced Creality 3D Version Mainboard Motherboard: Boosting Printing Performance and Reliability Review

This is by far the best upgrade I've made to my Ender 3 Pro. With this updated motherboard I was able to use the Klipper firmware to achieve print speeds of 250mm/s at a much higher quality than I was previously able to print at 100mm/s on the original 8-bit motherboard with standard Marlin firmware . Both speeds were used with BLTouch so you may not be able to get prints as fast without BLTouch, but you should see similar improvements in quality and speed.

This board is such an upgrade from the Stock 1.1.4 board that came with my Ender 3. It's very quiet. We used to have the printer in the garage under the bedroom and I had to print out prints before bed to keep "everyone" happy. The fans are now the noisiest part of the machine. I was able to put the printer in the computer room right next to our bedroom and it worked non-stop. It's great, not to mention a major upgrade from the old board with a dedicated BL touch port and filament low sensor…

Circuit board 4.2.7What firmware to use? There are a number of versions on the Creality site. I chose the one that included the BL Touch block because I installed it. This board goes where you think it will, turning your basic Ender 3 into an Ender 3 Pro with all the upgrades and upgrades as listed. The hardest part is installing and removing the old circuit board. I had a 4.2.2 board but wanted to make sure I had the best board for BL Touch. Check out my review of this fiasco. Everything on…