🎨 Convenient Custom Shop Pack of 12 - 16oz Paint Mixing Cups with Calibrated Ratios & Epoxy Mixing Cups Included Review

Mix and Match. Trying to separate them is a task in itself. They break if you try to take them apart. Not enough caps, can't store much mixed color due to lack of caps.

They are not reusable if epoxy resin is mixed in. They just break when you try to remove the epoxy residue. I've used others like High Teck which are much more flexible and you can easily break up the dried epoxy to reuse the mug. No problem if you don't care about the environment.

Very good cups. Easy to clean. When measuring the color, I can easily see the color through the cup. The color lettering on the mug will not be erased when cleaning for reuse. I used harsh chemicals when cleaning the cup and didn't grade at all. I've used a mug about 6 times and it's still like new.

These mixing cups are proven for mixing small batches of epoxy and two part flowable foam. The downside is that they can only be used once if not deleted. Only one use is possible with flotation foam. The reason these containers are single use is because unlike others I have used they are not flexible enough to break out of cured resin or foam after they have cured. These containers will separate if bent severely, but they only work well for single use.

Во-первых, если вы используете эпоксидную смолу West Systems, знайте, что они используют концентрацию 5:1, а в этих чашках ее НЕТ (по крайней мере, в упаковке из 12 штук, которую I bought). Also, as someone else said, the volumes aren't too accurate. I figured the best thing would be to take the mug I'm going to use to the kitchen, pour water in it, and mark each tier with a sharpie. Only then can you be sure that your concentration is right. Yes, it hurts, but it works. However, they boil down

I cast resin and acrylic so I ordered these mugs. I need exact measurements The measurements on these mugs are so far off as to be useless to me. The only thing they're good for is drinking from them. It's absurd to have an inaccurate measuring cup! I mean, why would you even make a measurement product that doesn't measure properly?!? FUNNY and very disappointing! If you are looking for mugs with exact measurements, you should try another product.

First of all, if you are using West Systems epoxy, note that it uses a 5:1 strength and these cups do NOT have this (at least in the 12 pack that I bought). Also, as someone else said, the volumes aren't too accurate. I figured the best thing would be to take the mug I'm about to use to the kitchen, pour water in it, and mark each level with a sharpie. Only then can you be sure that your concentration is right. Yes, it hurts, but it works. However, they boil down to regular heavy-duty plastic…

Gauge lines are grossly inaccurate. I poured 3 ounces of water (measured along the line on the cup). I then weighed the cup and water on my digital scale (with the scale at zero and the cup dry). Then I filled the cup to the 6 ounce mark and weighed again. The weight should double. It's not like this. Not even close. Also, the mix ratio lines don't even line up with the ounce lines. For example, in the attached image, I have circled in blue where "1" corresponds to a "1:1" mix. I then put a…