🚤 CZC AUTO 12V Submersible LED Trailer Tail Light Kit: Waterproof and Perfect for Under 80 Inch Trailer Boat Utility Trailer (Trailer Light Kit) Review

The light is excellent and definitely waterproof. Swapped headlights on my trailer. The problem is that the wiring harness that comes with the kit is complete nonsense. They look good and worked well initially, but after only a few months they rotted and broke. My headlights went on and off and I noticed that one of my wires had come loose. When I tried to strip it with wire strippers it just broke the copper inside. I even put my wire stripper on the lowest setting and it was able to hold some

This trailer lighting kit is exactly as advertised. It was relatively easy to install and good quality for the price. The instructions could have been better. There is nothing special about installing this kit, but the installation instructions for the side markers were completely wrong. They tell you to connect both wires from the side marker to the brown wire on the lighting harness. In fact, all you have to do is connect the brown wire from the tag to the brown wire on the harness and attach

Good lighting set! The light is bright and the wires appear to be thicker than the LED kit I recently bought at the port. Haven't submerged them yet but they seem to be working. One of the light side markers had a tear so I contacted CZC directly and they sent me a replacement asap. I received it a day earlier than I was told (the day after I gave them my address). Talk about fast customer service! I tested each bulb with a 12 volt battery prior to installation and they all worked great. Easy…

My son and I were replacing the headlights on an old trailer he recently bought. This light kit is very inexpensive and comes with very few instructions. If it weren't for the other reviewers, I'd still be doing the old trial and error dance. First you need to ground everything! Without exceptions. From the hitch connector to the trailer harness and each light, you need to ground everything: the gray wire at the side markers, the white wire at the tail lights, the white wire at the trailer…

I bought this product to replace a set of light bulbs on a small trailer. Both of my tractors have separate turn signal/brake lights and both have tail light converters. However, only one of them will make the trailer light work. So I assumed the problem was the available current and figured that LEDs might solve it since LEDs typically draw less current. I ordered this set and the carrier shipped it very quickly. Installed them on the trailer which was very easy apart from my decision to cut…

I use a 4x8 trailer to haul kayaks, a four wheeler, a garden tractor, lumber and motorcycles. I don't submerge it when launching kayaks, so I won't rate the lanterns' water resistance. Today I rebuilt my trailer. Total time from start (preparing materials) to finish (clearing things up) was 90 minutes at a steady, leisurely pace. After laying the trainer on its side and removing the old headlights, I used the old wiring to run the new ones through. Cable harness through the cable duct on the…