🚚 MAXXHAUL 70094 12V Trailer Light Kit: Ultimate Lighting Solution for Trailers Under 80 Review

I finally got around to installing it but one side is not working. It's been too long because I ordered it and I can't return it. Stay away from this brand, it looks like it will bring good luck or bad luck.

Light is great but throw away the wiring harness, not only is the wire very thin but the connectors are also of poor quality. I had to squeeze them with a pair of pliers needle to even them out and let them fit. I highly recommend upgrading your suspension and saving time later.

I have a bag and they were easy to install, they work pretty well except one of them didn't work so I would change the trailer cord and then have to have the other didn't work but the same one didn't work except sometimes the other didn't work and it turned out bad which had a loose wire. In an hour and a half. not very cheap, I would have preferred Harbor Freight but they weren't available

The product was just what I needed for a pendant that I made but didn't want to get rich. For the price and product for the money it doesn't get any better. Not an LED, but unless you use it regularly like I do and submerge it, it will probably last for many years. SUPER easy to install. Very impressive at this price point, highly recommended for those who want a functional base product. Don't be afraid to buy this, it feels like a sturdy and well made kit.

The light housings appear to be of decent quality, but the taillight wiring is short and the taillight is an uneven length. A lightbulb didn't work. It was frosty white. Didn't the builder notice that? The harness was a poop in the pool. Plugs looked very bad. I was lucky that I had the best connector that I spliced together. I also butted the taillights instead of using the cheap nuts that came with the kit. The harness is a very thin wire, probably #22. I got that to work though.

I only received them today so I haven't had time to test/fit them yet. However, due to negative feedback from others, I have decided to take these lights apart and point out all the hazard (red) and warning (yellow) points where water will definitely (red) or could (yellow) get into and cause these lights them to work. eventually it will fail or fail. It seems that the dark gray foam lining around the lenses "should" hold water, but will have to test this to see how well it performs in that…

Kit made with quality materials. I used plastic lights to replace broken ones on my old cargo trailer. This part works well. My only complaint is the 5 pin hitch that comes with the kit. The kit comes with both a male and female connector which I had to put in a vise and tighten with pliers to get it out I tried to insert the plug into an existing outlet on my truck and was only able to insert it halfway and then needed pliers to pull it out even after applying grease before plugging it in…

This and another set were installed on some of our trailers requiring new lighting required. The light works perfectly. However, the wiring harness becomes very cheap wiring over time. One page stopped working. Tried screwing it into the strap and couldn't. The wire itself broke at the slightest pressure. Couldn't even get bare wire with good wire strippers. The wire continued to unravel. If you only want light: probably a good deal. I kept the second harness, but after problems with the first…

This is the second time I've updated the wiring on my small 4x8 cargo trailer to make you think I'm doing it right. But instead I found a new way to confuse myself. I used the supplied nuts to attach the rear/turn signals and tightened them fairly tight. I didn't get my breaker and didn't use a ton of force because the threaded studs are built into the plastic. But I also didn't think of using a nylon lock nut or two nuts bolted together. So it's my own fault when I pulled in last night and…

Very happy with what I got and super great price. However, remember that we are not talking about high-quality and durable American lights. I had two problems. #1: Look at the pictures. No matter how professional your installation, you will have corrosion problems caused by the cable lugs provided. Unless you live in the desert, rain and humidity will corrode where the wiring harness connects to each light. This can cause the light to dim or stop working altogether. Use heat shrink butt…