🔪 High-Performance Freud D12100X 100 Tooth Diablo Ultra Fine Circular Saw Blade 12 inch - Ideal for Precision Cuts Review

Overpriced for what it is (it's just a saw blade!) but well worth the money if you plan on using it for a lot of projects. round etc.). Much better cuts compared to the 40 tooth blade that came with my 12" Ryobi combo miter saw. It's easy to change the blade - if a beginner is worried about this, don't worry. This blade leaves a smooth finish on the cutting edge, won't scratch the surface and leaves less scrap (finer kerf) than a standard 40 tooth blade.

Freud Diablo blades are the best blades on the market in my opinion. I have several 40T and 60T saw blades for my 7-1/4" circular saw and I really like them. After knocking tons of splinters off the frame wood, I replaced the standard DeWalt carbide blade on my DeWalt miter saw with one of these. I was concerned that the 100 tooth version might be a bit slower, but I didn't notice any difference. I actually noticed that every edge is now smooth as glass. I am very glad that I bought this sheet!

The part not visible in the picture also grinds 200 grit. Diablo blades became my favorites after using one at work got this one for my miter saw. This blade cuts so well and so easily it's a little intimidating. But if you're not afraid of your saws, you're doing something wrong. The old "saw" that "God forgives, there will be no saws" is very true. I've only done a few projects with this before, but I had to swap out my table saw blade for a 10" general gauge Diablo because it was so good. A…

I have always been happy with the blades that come with the saw. I've used a 60-tooth blade recently, which certainly felt sharp, but I've always been frustrated with edge burn and end snaps. Even with the zero-free miter saw rest set, I still had problems with the end piece detaching, which required grinding the end of the part, which is always a problem with complex, repetitive work, such as formwork panel. And then I have this blade. The difference is like day and night. I can say without…