🔧 Danco 80842 Universal Medium Canopy Handles with Chrome Finish Review

Good quality product. Works well. The only thing I would like is that the surface of the handle is not smooth as it is difficult to handle with wet hands.

So I have a very old 2 hand compression valve from the 1950's. I can't tell what American stander this is? fist price? Not even a plumber friend of mine knows. I've done an endless search on the internet but no luck, this gets taken care of.

Works if you install it and never use it. Otherwise the thing will break. The included set screw is too thin and the included hex wrench does not fit well on the hex bolt, which can cause the bolt to break. The handle is not attached to the handle, it just sits loosely on it and falls out with every turn of the handle.

My shower handles broke so I ordered replacements so I don't have to turn the shower on with a wrench. I was excited to see them the same today and went to install them. Find out how easy it is to upgrade your existing grips. This product does not include screws. It uses the existing screws from your old knobs. Since there were no screws on my old grips, this product was useless to me. Please note that you will need existing screws when purchasing this product

Danco universal replacement kits used to have it all - this one assumes you are reusing the handle screws (I hope you didn't damage the heads when removing them). About 10-12 years ago I used a Damco kit with plastic grips. I wasn't surprised that plastic handles lasted so long, but after seeing this kit I would be surprised if metal handles lasted 10 years. Attach the inside of the handle off-center.

that's a certain 'resemblance'. Average shower handle played out (3 handle shower faucet) - we couldn't turn on the shower without tongs. bought pens from HD and L which were much larger than this item. I had to send everything back, didn't fit. What I love about this item is not just the price but the fact that it fits on any screw and connecting with the included Allen key was even better. It took less than a minute. I thought the screw was too stripped but it worked. Many Thanks.

1. Adjust the hood handle so that you can install the screw to prevent the hood from falling off the splines of the mixer shaft ::: Turn the 3 screws slowly by no more than 2 turns and facing the center of the provided lock, keeping the center screw hole always visible by turning the provided lock screw by screw until it is secure and your screw hole is still visible. Then put a canopy over the lock and tighten the bolt so it doesn't fall off the stem serrations.2. A Frequently Asked Question…