Universal DC Sports EX 1012B Stainless Steel Review

I had to trim the exhaust pipe about 30cm to keep it from being affected by my Jeep TJ's new aftermarket shocks and suspension upgrades. This tio fit perfectly and with the set screws it was easy to install. I sanded and welded it to keep it from falling off when hitting tricky trails and bumps in the road, and it looks great tucked behind the suspension under my Jeep. Looks really good to those who look closely enough to see it and I get lots of compliments on it. I've been waiting to check it

The price can't be beat. I cut the intake end off completely and had a mate weld it to my 2020 Chevy Colorado 4 cylinder. It doesn't make the sound louder, it just changes the tone. Imagine screaming through a cardboard toilet paper roll. It's a bit more aggressive in tone and produces what I would call a sort of "duck call" effect, the kind of growling or low grating noise you might hear from an off-road bike. Anyway, in the video I'm spinning and holding at 2k, 3k and then 4k rpm. Mind you…

Tried to install the attachment on my 2016 TRD SR-5 Tacoma. I cut off the end of my exhaust where it extruded to 2.75 inches. I couldn't get a tip on the 2.5" exhaust end with the included hardware. Eventually I broke the hardware and ended up cutting 3 2.5" thin intake slots and used two stainless steel clamps to really crank and compress the tip intake on my exhaust pipe. It's going nowhere. I'm happy with how the product fit It is very flush with the exhaust pipe (no air gap) and matches my…

Had to use 2 large muffler clamps and a pipe extender after having to cut part of the original 1997 Ford Ranger pipe. I also welded it on and then painted the whole exhaust pipe with high temp paint. It looks and sounds better than before, but the engine is actually louder than the exhaust until it's over 45mph and you only hear it when the speed isn't steadily picking up, but I prefer it. The original exhaust seemed to be too close to the truck body so I ordered the end of the exhaust and now…

The DC Sport Exhaust Trim looks great and has a good build quality. I have a 2015 Toyota Tacoma, the end of the exhaust pipe was larger so I cut and removed right behind it so the DC exhaust would slide further. (Note: I bought two DC tips - the larger diameter 2.87 inlet that fits without cutting BUT sticking out too much - the smaller 2.25 inlet, cut off the stock exhaust tip and pinned it up to make it look right So I Used GEARWRENCH exhaust and tailpipe cutter - 2031DD (Amazon item), WD40…