🚗 Enhance Your Vehicle's Performance with the Delphi ES20000 Oxygen Sensor Review

According to the description it fits in my car. So make a small adjustment on the inside of the connector as the rest will not fit in the recess.

I bought these O2 sensors for my truck a while ago as OE replacements. They fit perfectly and work as they should. There are no problems or complaints here.

The OE sensor comes with a quality factory made wiring harness terminating in a direct connect connector (no splice). The heat protection cable is shortened to the same length as the original factory devices. Works as advertised, come in, no problem replacement.

Fits, works as expected. Suitable for rear or bottom sensor position. (2) Required The bottom sensor connector is "square". The corresponding top sensor is http://www.amazon.com/gp/product/B001JEG0M8/ref=cm_cr_ryp_prd_ttl_sol_23 The matching sensor has a "flat" connector.

Great buy! They were HALF cheaper than the Chevrolet dealer and I get the best prices from a friend who works at the dealer! Super easy installation and same quality as the dealer. I don't give a fuck about my lofty suburb without a name. My suburb uses FOUR o2 sensors! Those were just two of the four I needed. I can't remember if they were upstairs or downstairs. But anyway, if you want to replace all four, you're going to need them. They were for my 2002 Suburban Chevy 1500. 5.3 liter 2wd…

I bought everything for oxygen sensors for my 454 Chevy engine in my RV. think Delphi is a quality brand. The two front ones were fine. The rear two post cat sensors were getting hot and seemed fine, showing 0.45 volts on the scan tool. never changed, i spent hours looking for a short or melted wire but nothing was found, after starting the car for about 15 minutes i started sending pending code PO140 and PO160 inactive sensors. I had them installed, figured I would have to reset the PCM to…