🚘 02-09 Trailblazer Headlights: Chrome Housing with Clear Corner, Replacement by DNA Motoring Review

They are perfect. They fit exactly how they should. Gives a new look. Even better, I can actually see at night. I added LED headlights and now everyone is blinding. But I see

Absolutely beautiful headlights, they just don't match the 2008 Trailblazer LT. The standard Trailblazer has a grille section that crosses in front of the headlight, while the LT trim package doesn't.

Comes with high and low beam bulbs, you will need to keep the turn signal bulb and side marker bulb. Easy installation - 20 minutes work. Replacing both nodes and reinstalling the grid.

The passenger side will not fit when the insides are removed. There is debris in the lens on the driver's side. Note the lack of screws. 2 hours on hold with CS before hanging up suggesting I would still be on hold if I didn't. Didn't expect an expensive or high quality product but expected a decent CS at least.

These are basically standard headlights with white indicators instead of amber. There are no problems with leaks and fogging. The pre-installed bulbs only lasted about 3 months. I just replaced them with other Sylvania halogen bulbs. Overall very happy with the purchase.

FITS PERFECTLY. SMALL PRINT (REMEMBER OF YOU). LAMPS ARE NOT INCLUDED. JUST DON'T EXPECT THAT THIS CAN TURN THE LIGHTS ON. PLEASE READ THE LISTING CAREFULLY - THAT'S ALL I SAY BUT OVERALL IT IS A GREAT PRODUCT THAT FITS PERFECTLY AND IS EASY TO INSTALL.

I bought a 2005 Chevy Trailblazer EXT a few weeks ago and as shown in the first picture the headlight was damaged. I immediately replaced them with these headlights. Installation was a breeze. The only tool I needed was a flathead to gently pry off the grille and headlights. Be sure to remove the high and low beam bulbs from the old assembly before discarding it. The new building does not come with them. The third picture shows the picture before when I first bought the car. The second picture…

After receiving my first new pair of headlights, I opened the box to inspect each headlight assembly (left and right sides). I noticed that one headlight was not assembled correctly. The clear lens cap was not fully installed and sealed, but not sealed. The other headlight was properly sealed and glued, but one of the sockets was not installed properly and the wiring harness was pulled so tight it almost cut the wires from the socket and the socket was sticking out of the back of the housing…