🚗 Dorman 926-445 Front Passenger Side B Pillar Molding for Chrysler/Dodge Models - Black Finish Review

The lid came with two strips of foam tape covered with a blue stripe that needs to be removed before installation. However, they are only on one side. On the other side are three foam squares. They don't have a blue coating, they're just slightly tacky. I can imagine it going away the next time I hit the freeway.

This was easy to assemble on the 2014 Town & Country. The price was on par with other sites with the addition of Prime Shipping it was excellent value for money. It's really picky, but the ONLY reason it didn't get 5 stars is because it doesn't quite match. You really have to look to notice it, but it's different. But I would buy another one if needed.

Although no instructions are included, installation is fairly easy. Don't forget to remove the torx screw holding your old one in place. If it's broken, you may need to hold it with pliers to remove it. Slide the old item up to remove it. Tip: When installing a new one, do not remove the protective film on the adhesive. Just remove an inch or two. This allows you to move the part up and down during installation. Leave enough space for you to carefully remove it when it is in place. Very happy…

This review was posted 10 days after installation. There were no instructions but it didn't matter as it's pretty easy to see how to install. Checking the blue sticky strip that says to bend the part you are holding outwards helped a lot! The glue seems to stick to the underside of the fairing. I've noticed that the underside of the fairing is loose and as children get in and out and hold on to the fairing I see that eventually it breaks easily again. There is glue on the top and one side so in

I replaced the B-pillar upholstery after the original OE trim came loose while driving downhill and on the freeway. The cover fit well and was easy to install. I wiped the areas where the double sided tape would stick with alcohol. It is important not to remove the backing from the tape until the overlay is in place. Once the panel is in place, you can pull on it to remove the backing from the tape to secure the panel and its final position. You will need to press the tabs and align them with…

Installation is very simple, but here are some instructions and details to keep in mind: 1. Remove the screw (requires a hex sprocket) INSIDE the B-Pillar against the underside of the molding.2. Make sure all previous sticky pads have been removed from B.3. DO NOT (repeat, NOT) remove the adhesive backing from the new part until it is in place. This will make installing a new part in the field much more difficult. Align the two tuck-in tabs on the new part over the corresponding slots in the…

This part is great for our 2014 Chrysler Town & Country Van! Contrary to what other reviews may say, it does NOT "stick" easily. It also has no instructions. :( My husband and I sewed it for a long time, and he was a military mechanic! INSTRUCTIONS: In the middle of the piece on the back there are two round rubbery areas with a rounded rectangle in the middle. They should be VERY tight against the wider part of the corresponding ones Slots on the van itself are pressed and then (when pressed)…

Perfect replacement and a fraction of the cost. For those who call it cheap and break during installation. it's a thin piece of plastic. It will break if you bend it too much. You MUST bend it a bit to get it in. So if it breaks, it's only because you weren't paying attention. - For those who say he flew away the first time you hit the freeway. You didn't install it correctly. There are two hooks that fit the car, there is tape and it screws on (the screw is not included but should be there…