Enhanced LED DRL Headlight Assembly For 2009-2018 Dodge Ram 1500/2010-2018 2500 3500/2019-2022 Dodge Ram 1500 Classic With Sequential Turn Signal And Clear Lens - Quad Model Compatible Review

The drivers side light on my 2012 Ram 1500 points all the way to the right on the road shoulder, like it's mega cross-eyed or something, and leaves a big dark spot down the road exactly where I need to see the road. If my fog lights weren't so good, I wouldn't be able to see at all with these. In addition, it seems to have terrible reflective ability, as my original lights were way brighter. On top of that, the right light kept cutting out until it finally died. I wanted to return them but…

They shouldn't send with the bulbs because you cant see anything and lights shine down.Put SEALIGHT X2 H11/H9 Low Beam 9005/HB3 High Beams in them and they are great.Well worth the money.

These took in water almost right away. Not just a little condensation, there was about an inch and a half of water in the housing. I had to remove them and drain it. The lenses yellowed within a year and became unusable shortly thereafter.

They look good, specifically the sequential turn signal and running light. But my lord, you can’t even get these things close to being adjusted properly… no matter what I do they’re too low, and the driver side light is shining directly at the right side shoulder. The low beams were terrible, but better than the high beams. I also had the smoked lenses and it really destroyed the light output. I have 20k lumen white LED’s and it looks darker than the worst halogen ive ever had. If you wanna see

The install was quick and the quality was great however less than eight months into the new headlights the quality of the outside Lens started to peel and discolor. Now I’m either looking for a warranty swap or new light housing assembly

Arrived packaged well. No scratches on lens and whatnot. Problem I have is that they wont adjust high enough to be useful. much lower then stock and can not get them to adjust and higher.

Install would have been much simpler if the LED system was wired directly into the turn signal plug. I spliced and hardwired with plugs myself. So far so good they look awesome, just need to fix all the error codes. The MX+ should fix that!

Poor fit. you can see in picture. the factory lights were flush with the fender and you can see in this picture the new ones didn't fit the same. Wires to bulb sockets were short wouldn't reach bulbs without modification. Also aiming would not adjust headlights far enough up. Ran out of travel on adjustment before finished adjusting. I returned them and put the factory lights back in.

STOP! Do not buy the dark housing with smoked lens in these lights. I got some and absolutely hate them. I put the best,most expensive led bulbs in that my local body shop had an it’s still like driving around at night with a frikn candle in front of the vehicle. Installation was easy enough but they should be illegal as far as brightness goes. It’s totally not safe driving thru wet/rainy/cloudy/dusky conditions. Hope I helped someone out

Due to needing replacement I had 3 sets. All of them accumulated moisture inside. I will not again, nor would I recommend, purchasing these.

Had to slightly scrape a couple screw holes to line up. They do point down still but they work, also upgrade your bulb the black house sucks up the light pretty bad