🖥️ Enhance PC Cooling with EZDIY-FAB 120mm White LED Dual-Frame Fan, High Airflow & Low Noise – 3 Pack Review

I was a bit hesitant at first about buying these as they aren't a brand I'm familiar with but damn I'm glad I did. They have a thick rubber outer rim that fits snugly and camouflages them, giving them a premium look. The screws were a little harder to turn than I've experienced in the past. They also didn't want the threads to be straight all the time, but they hold tight. The thick rubber rim can also be a problem when placing multiple fans close together, like I did on the front of my case…

I have used 6 of these fans on my MATREXX 50 case and they look great. Gives me pretty good temperatures and is true white with no color cast. My only complaints are that the installation process was a bit odd (my case might not be compatible, to be honest I didn't do too much research on these fans) and that the fans are a bit noisy. However, nothing particularly disturbing. I definitely recommend them.

It's cheap, all 6 fans work and appears to be a good product. It should be 5 stars, but one box is missing mounting screws for 3 fans. Luckily I replaced the old one which allows me to reuse the screws. Too bad the power cord is a bit longer so I can place it more discreetly. The lack of small parts is a big problem with projects and to ensure that the device works properly. *************************** UPDATE: Changed from 1 to 4 stars due to seller willing to send screws but I need them no…

It's nice that the fans have pads on either side. However, this made it too thick and the screws would not snap onto my heatsink. After removing a page, everything worked fine. The sizing was a bit off because I had to make a little effort to fit it when mounting it on the radiator. The frame is bent a little, but just enough not to scratch the fan blades. I've been monitoring temperatures more closely over the past 2 months so technically the fan stopped working properly in less than 3 months.

Fans have anti-vibration rubber isolators on all four corners on both sides. The cables are about 10 inches long and have 3-pin fan connectors and molex connectors. I used 6 of these fans in an Antec case, connected two of the fans via molex and then connected them to the motherboard via a 3 pin header. Since these are not PWM fans, the brightness of the LED rings directly corresponds to the fan speed. When my system is running at low temperatures, the rings glow dimly and get brighter as the…

Very well made and easy to install (dual option - smaller 3 pin or larger 4 pin molex) - Good cable length. The blades don't glow, but the rings on the sides glow nicely. I only needed two, but decided to use all three in my aging Zalman Z9 case. at the top of the case, which is a problem with some sleeve bearings/cheap fans.

I bought two or three packs of these fans for some of the custom builds my daughters and I did. All six worked and felt like they were made out of quality materials. They are quiet and the RGB looks great. If you only use three pins from the motherboard, the fans will glow red. If you want full RGB you will need to use a four pin power supply from your PSU. I would recommend them to everyone. You are of great value!