🚗 Front Windshield Washer Nozzles Wiper Spray Kit for Dodge, Ram, Jeep - OEM Replacements: 4805742AB, 5116079AA Review

A nipple on the original sprayers is broken (see photo of old and new spray heads in my hand) and needs to be replaced. They looked just like the originals and installation was a simple snap. Then install the handset. The spray pattern on one of them isn't perfect, but it still sprays liquid onto the windshield to clean it.

Both replaced. One sprays well, the other doesn't. It just flows over the hood like a garden hose. And of course the good one is on the passenger side. Since they are locked I am afraid of trying to change them and breaking the plastic. If the quality control was better, both would work well and the bad one would never leave the factory.

The washer nozzle only sprayed about 1/2 the way up on the passenger side windshield. After some investigation, the nipple on the nozzle was cracked. When I tried to take it apart, it fell apart completely. Parts broke off in the rubber knee. I cleaned everything, connected the line and ordered this replacement part. When I received the part, without exaggeration, I was able to install it in less than a minute.

Easy installation on PT Cruiser. The originals have cracked over time from overheating. They splatter on the windshield - not as pretty a pattern as the original, but they work and are a lot cheaper than what the dealer sells them for. (Due to heat damage, I wouldn't take them out of a landfill.). Was very glad they came with spacers/gaskets otherwise they would be too loose in the bonnet.

When I compared these nozzles to OEM they were cheaper so I was skeptical at first. However, having installed both attachments, I am very happy with them. This spray is better than OEM. If they work for the OEM portion, then I'll take them anytime. Tip: If like me you are reusing a 90 degree elbow and T-connector, make sure they are very clean internally and 100% free of broken plastic from previous attachments. This can cause a clog and later restrict water flow.

As the nozzles were as advertised and very easy to install, the nozzle itself did not do the job. The jet from the nozzle hit the windshield wipers and the underside of the window. The spray didn't even reach the center of the window. I even tried increasing the angle with old rubber washers from an old injector but to no avail. As the saying goes, especially in this case, "You get what you pay for." Buy them if you can't afford a better brand, as the spray will eventually end up on your…