🚤 Marine Boat Car RV Truck Rocker Switch Panel - FXC 5 Gang with Dual USB Slot Socket, Cigarette Lighter, Voltmeter - Waterproof Blue LED, 5V 4.2A (5B Blue) Review

I've never had anything like this. Installed it in a plastic ammo box to simplify the electronics in my tiny boat. This works as expected. Only downside - the cigarette lighter cover doesn't hold up. It's ok but a bit annoying as I'm concerned that water might get in while it's on the water or it'll just break from moisture. But time will tell. Highly recommended!

LOVE! Amazing rocker switch panel for the price! Very high quality, nice wiring and connectors, used a 9v battery to test before installing and it works great! Each switch has its own built in 15 amp fuse in the waterproof mount, the sticker pack is great too! Overall very happy with this product, I highly recommend it and if I need another one I will definitely buy again!

Guys I bought this item for a great price of $25 thinking it was waterproof as advertised for my boat. Switches are NOT waterproof. 3 out of 5 stopped working when it rained on my boat and when I hose down my boat at home water gets into the switches and turns them on. The blue LED stays on even when the breaker is off, powering my devices when they're off due to a water short. I just received a refund from Revain and will be purchasing waterproof switches to replace on the panel.

Not for marine quality! After 8 weeks on the boat the switches stopped working. During installation I lubricated each connection with dielectric grease to prevent corrosion. When the switches stopped working I checked all the connections only to find there was no power and the switches were off. I decided to cut the switch and found that the contacts inside the switch were badly corroded. The panel was under my trunk on my boat and was never directly exposed to water.

All switches are wired in series with jumpers to pass unconnected components through such as a string of Christmas lights. That means everything uses the same wires to deliver power. This would be fine except the wires are 18 AWG wire. This isn't enough to handle the load when all the switches are connected to components that draw 12-15 amps each. You can burn your wires without setting the fuse the way it's connected. I wouldn't use this thing without putting a 30 amp switch between it and the

So this panel has its advantages and disadvantages. It has built in fuses on each switch which was actually the deciding factor for me.2. Although it looks like a plastic sheet, it's actually metal. Found this when I accidentally poked it with a drill and it was shiny under the paint. Pleasant surprise!- Cons -1. My nasty surprise came when I tried to bolt it to the side of my aluminum seat. The screw made it maybe 1/16 inch before it sheared off. Also, they are not stainless steel. I'm still…

Depending on how long the wiring going to your battery will be, the wires on this one will be narrow. Its wiring is 16 GA for positive and 18 GA for negative. So if you need to run battery cables longer than 6ft I wouldn't go with 16ga. I would connect 14ga to at least this panel. I'm using this thing because I need to reassemble the whole thing. I plan on using one of the switches to turn everything off as my jeep doesn't have a high amp wire with a key. So I plan to run the power wire to the…