🖥️ GeekPi Raspberry Pi 4 Fan and Low-Profile CPU Cooler with RGB Cooling Fan and Heatsink - Compatible with Raspberry Pi 4 Model B, Raspberry Pi 3B+, and Raspberry Pi 3 Model B (Silver) Review

Great for cooling Raspberry Pi 4. I preferred it to the higher version mainly because of the potential for more heat pipe contact with two separate 5- Millimetre-heat like pipes going through the CPU block compared to a single pipe in the high version (https://www.amazon.com/GeeekPi-Raspberry-Cooling-Cooler-Heatsink/dp/B07V35SXMC ). Installation: I took a dremel with a buffed bit and buffed the area of the heatsink that touches the processor on the rPi and buffed the top of the rPi processor…

I ran cpuburn directly on a Pi 4 Model B 8GB for 15 minutes with the CPU overclocked to 2147MHz and the GPU to 700MHz and the highest temp the I saw was 48C. I used the Grizzly Kryonaut Thermal Thermal Grease instead of the included thermal pads, which probably helped drop a few degrees, but overall this stuff kills when you're building an emulation system and getting the best possible performance with high reliability. Two thumbs up, highly recommended. UPDATE: I saw that another reviewer has…

Great fan for PI4. I managed to overclock to 2100GHz. With the fan running at 5 volts, the PI never exceeds 60 degrees, even at full load on all cores. Standard PI won't do this even at standard frequencies. I purchased this case on Etsy from EsotericAvenue. It offers more protection for the PI.

I've been looking for something different and this fits very well, perfect fit and am totally amazed at the quality. I put a Noctua NF-A4x10 5V fan on it, I've never tried a standard fan - I don't like RGB fans, I had to remove heatsinks on RAM, USB and Eth, but that's ok. I also got a 2x20 40 pin cable and an extension to push things away from the board. I am using Canakit Rpi4B and just removed the top cover. everything still fits in the suitcase.

I ran cpuburn directly on a Pi 4 Model B 8GB for 15 minutes with the CPU overclocked to 2147MHz and the GPU to 700MHz and the highest temperature I saw was 48 ° C. I used Thermal Grizzly Kryonaut thermal paste instead. of the included thermal pads which probably helped save a few degrees, but overall this thing kills if you're building an emulation system and want the best possible performance with high reliability. Two thumbs up, highly recommended. UPDATE: I saw that another reviewer has a…

Great for cooling Raspberry Pi 4. I went with the higher version mainly because I liked the potential for more heat pipe contact with two separate 5mm heat pipes that run through the CPU block, compared to a single pipe in the high version (https://www.amazon.com/GeeekPi-Raspberry-Cooling-Cooler-Heatsink/dp/B07V35SXMC). Installation: I took a Dremel with a polishing attachment and polished the area of the heatsink that will contact the processor on the rPi and polished the top of the rPi…