🚗 Geeon Red 12V Car LED Interior Light Strips: Brighten Up Your Vehicle with UL Listed, Pack of 4! Review

I've bought three different sets over the years and this one wins the cake. The wires are stronger than the rest, easier to strip (though delicate), and have POS+/NEG wiring, but don't label them as such. They are already equipped with 3M tape - what a concept, right? I'll hang them on the car, they need sticky stuff. These are the only ones I've bought that do this. Thank you Geon!

All pre-assembly work on a motorcycle trailer. 3 were as lights in the trailer and I retrofitted a brake light. They are no different from many ads as they are waterproof and ephemeral. They didn't work after a ride so I'm not sure if vibration or rain worked. We rode in the rain for several hours. Retrofitted brakes bother me the most because I don't know if they can be rebuilt again.

I wanted to put some LED strips on my bike just to highlight the chrome so I could be more visible on my morning commute. It was the perfect choice. I ended up buying an SAE connector (about $8) and plugged it directly into the battery rather than messing with the bike's wiring harness. All 4 LED strips work properly. The adhesion seems decent enough and you can tie it however you see fit. I would definitely buy them again.

I put them on the bottom of the hood with a switch so that when the hood is opened, the light goes to. The headlights are so bright that I can drive all night without extra bulbs, unless I have to work on some hard-to-reach spots on the engine. Given the low battery, I usually open the hood and leave the lights on at night to better illuminate the camp.

I installed these strips on my boat (yellow) under both dashboards, along the inner side rails, (white) engine, battery and storage compartments. Yellow repels bugs and adds a nice shine to the bottom area, while white brightens other areas when you need to open them. I gave the setup 4 stars because the advert says you can use them with small double-ended pens. If you do this, the voltage and ground pins will be on opposite sides of the strip connection and one side will not light. I had to…

Advantages: - Works with different voltages. I managed to get it working with 2v, 8v and 12v. It can be lighter and darker. The higher the voltage, the brighter the LED. However .Bad: - Unknown minimum required amplifier. And tech support can't tell me what the minimum amp is needed. This makes it difficult to determine why it's not working in a particular situation and what needs to be fixed to make it work. By trying it out I know that 1A or 1.5A is not possible. Works on 15A. Does it work…

You are amazing. They are very light and have 3M tape on them. Reviews saying they won't hold up or fall off are associated with improper surface preparation. So, here are some tips. Be sure to install in over 70 degree weather. Make sure the surface is completely clean. Then clean again with alcohol preparations until nothing can be seen on the alcohol swab. Then I strongly recommend using 3M Adhesion Booster 4298. Wait for it to dry and then stick the onions to the surface. Remember you only…

I use these lights as my car's auxiliary daytime running lights. No, they are not as bright as the LED daytime running lights that come standard on many vehicles, but they are still bright enough for such LED strips. Maybe the ones I labeled "Max LED's" are a bit brighter, but the ones I've seen don't have as many LEDs per foot as these lights. I would describe the white tone as "cool white" but it's not as bluish as other cool white LEDs I've seen. On the types of LED strips I have experience…