🔌 Versatile GenBasic 80 Piece Female to Female Jumper Wires: 4 and 8 Inch Lengths Review

No complaints. Of course, treat them with care as jst connectors are not designed to be plugged/unplugged permanently. I had connection issues after prolonged use, but that's to be expected. They're cheap, just remove the ends when this happens and use them on the jumper and use the new one.

Doing hobby projects with Raspberry Pi and Arduino. These cables are ideal for standard 0.10" pitch Raspberry Pi GPIO pin headers or other standard breadboard connectors. For a standard Arduino you will need a male or bare ended wire, the same gauge as theirs but with different connectors on the ends.

I create Arduino projects all the time. Most of them have some external devices connected to the Arduino board. I use them for connections. Multiple wires are easily separated from the bundle to make connections. The only change I want to see is the black and red wires side by side for power and ground.

So I'm building a HeathKit digital watch - an updated one I built in the 70's. And that requires cutting a 4 inch strip from six wires, tinning the ends and soldering both ends to both the display board and the control board. I did this once and decided the next set needs to simplify this step a bit. Voila, GenBasic 80 pcs "male-male" and "female-female" (4" and 8") were not only the correct length, but also followed the standard color codes. Just great! With the additional purchase of…

I needed 4 inches to connect my Raspberry Pi to a mini snap switch so I could reset the Pi out of the box without unplugging the power cord. I put 2 pins on the Pi's reset pins and wanted to cut off the ends on the other side to solder the switch. They turned out to fit the thicker switch contacts so I didn't have to use a soldering iron and it saves time as I have to make quite a few of these. I have many other uses for them as well, including peripherals that use the I2C interface for the Pi…