Header banner
Revain logoHome Page
🔧 gizmo dorks 1 additive manufacturing supplies logo

🔧 Gizmo Dorks 1 Additive Manufacturing Supplies Review

3

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.3
🖨️ 3D Printing Supplies, 🏭 Additive Manufacturing Products

View on AmazonView on ЯM

Media

(4)
img 1 attached to 🔧 Gizmo Dorks 1 Additive Manufacturing Supplies
img 2 attached to 🔧 Gizmo Dorks 1 Additive Manufacturing Supplies
img 3 attached to 🔧 Gizmo Dorks 1 Additive Manufacturing Supplies
img 4 attached to 🔧 Gizmo Dorks 1 Additive Manufacturing Supplies

Description of 🔧 Gizmo Dorks 1 Additive Manufacturing Supplies

1.75mm diameter, 1kg net weight, HIPS Filament. Filament Roundness: +/- 0.07mm. Filament Diameter: +/- 0.05mm. Recommended Print Temperature: 210 - 230°C, depending on printer model. Compatible with RepRap, Makerbot, Afinia, Solidoodle or any standard spool based 3D printer.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 3 out of 5

Ideal for 3D printing Raft/prop

I have a 3D printer with two extruders. I am using ABS on one extruder and HIPS on the other extruder. With Makerware (or another slicer) you can set up your prints to use HIPS through one raft/support nozzle and ABS through the other. not connect well at all. I figured I needed Limolene to dissolve the material. But I haven't even opened the bottle yet. I wouldn't do a real 3D print with ONLY this material. I've noticed that HIPS warps a lot with higher walls and is quite brittle. For HIPS I…

Pros
  • Filament diameter: +/- 0.05mm
Cons
  • Quick start guide

Revainrating 5 out of 5

Non-general purpose filament

Given how this product is advertised I took a roll to see if it was a decent one General purpose filament could act. The first problem I encountered was very poor adhesion to the bed. I use Printbite for my beds and it always sticks to the thread. Anyway, it sticks to some threads too well, but it always sticks to something. After the table temp rose above the ABS temp, I got some adhesion to the table - enough to allow small print to be printed. It took three attempts to print a 4.5mm high…

Pros
  • Recommended print temperature: 210-230°C depending on printer model
Cons
  • New competition has emerged

Revainrating 5 out of 5

Works better than expected.

Purchased for my PowerSpec Pro 2.0 printer (like Flash Forge Creator Pro, MicroCenter brand only) with dual extruder. Bought to use as support material. Judging by the reviews on YouTube and other sites I didn't have high hopes for this as they believed it wouldn't stick to the base material so it would have to be attached directly to the table. In my case I printed a few details and was done. I'm glad it actually adheres to the base material quite well (I printed PLA as the texture and HIPS as

Pros
  • Diameter 1.75mm, Net Weight 1kg, HIPS Filament
Cons
  • Available in White only