Gizmo Dorks 1 Review

Given how this product is advertised I picked up a spool to see if it was a decent general purpose - Dental floss could act. The first problem I encountered was very poor adhesion to the bed. I use Printbite for my beds and it always sticks to the thread. Anyway, it sticks to some threads too well, but it always sticks to something. After the table temp rose above the ABS temp, I got some adhesion to the table - enough to allow small print to be printed. It took three attempts to print a 4.5mm…

Purchased for my PowerSpec Pro 2.0 (same as Flash Forge Creator Pro, MicroCenter brand only) with dual extruder. Bought to use as support material. Judging by the reviews on YouTube and other sites I didn't have high hopes for this as they believed it wouldn't stick to the base material so it would have to be attached directly to the table. In my case I printed a few details and was done. I'm glad it actually adheres to the base material quite well (I printed PLA as the texture and HIPS as the…

I think the mechanical properties of HIPS are pretty standard: very stiff, very light, a bit prone to warping on the build plate even at 110C, but not as bad as SECTION . Actually the weight stunned me, you'll probably get a lot more filament than you would expect from a 1kg net weight if you're used to PLA or PETG (ABS I'm not sure). Neon orange, but glows orange in the dark. As if it were 20% white and 80% orange dye. Sections 0.8 mm thick and thinner are slightly transparent. I originally…