GraBarsUSA Steel Grab Handles for Jeep 4DR JK JKU (2007-2018) Wranglers - Blue - Front Only - Made in the USA! Review

Very durable and reliable quality. Haven't had a chance to use them yet other than get on the jeep. But a strong mount should be more than enough. They prevent the sun visor from pressing fully against the windshield, but the visor drops low enough to be useful. Due to the angles of the mounting holes, the screws are a little difficult to install. I was worried that I crossed two screws in, but after removing and checking the threads, they turned out to be fine. Be careful and screw in the…

Obvious handrails. HEAVY and durable. I installed them on my boosted JK Unlimited and my wife and I love them. This makes getting into the jeep much easier and, in contrast to fabric handrails, without stretching, twisting or loosening the handles. GraBar rails are very strong - I can move and rock my jeep on the rails and it doesn't bend, rattle or wobble. Installation notes from some videos I've watched on YouTube is that it's really easy to undo the screws on the vertical part of the window…

Installed on the JKU Sahara 2012 with a 2.5 inch lift. They are very well done. You can find installation instructions all over YouTube. I thought I had secured the front passenger side handle, but a constant rattling sound told me I was wrong. It makes my 5'1" wife's life (5'2" according to her but doctor's office, let's put it another way) a lot easier getting in and out of the jeep. Don't forget to put something in the jeep upright when removing the bolt there as it will tend to fall into…

These handrails are very strong, sturdy and durable. A very nice update for the Jeep Wrangler JK interior. The rear ones are very easy to install, literally in minutes. The front installation required some effort. I unscrewed the factory screws and put in new ones, but it was very difficult to unscrew them. Hard to pull Jeep Loctite used on factory bolts. It is very difficult to try to start new ones. Eventually, after some trial and error and inserting the bolt into the post, I got it, but in…

This is the second set of grab bars I have installed. My advice is to install them for you and pay where you buy them! The first sentence was only about 5 years ago. I had already forgotten how upset I was at the time and bought this 4 door kit. Everything is fine in the back, but in front - trouble! 2 bolts going in 2 different directions at 90 degrees to each other and although the instructions say to strip the threads of Loctite they are still tight and you will most likely drop something…

Arrived well packaged, quite easy to install. A little expensive, but as they say, buy once, cry once. I followed the advice of others and put a paper towel in the plastic pad to keep the bolt from falling into the chasm. Luckily I was able to remove it without losing it from the nest. As another reviewer said, the washers are flat. So when you tighten everything, the handle itself will only sit on a few points of the washer. If the pad were designed to match the size and angle of the handrail,

I love them. The rear handrails were installed in minutes. The front bars definitely need more attention because of the terrible A-pillar cover. Luckily, we were in the middle of election season, so every day I received 10,000 flyers from various candidates and organizations in the mail. It was just a matter of making a 2-3 inch tube from a flyer and inserting it into the A-pillar access hole for that bolt. It came out easily and did not fall into the abyss. However, I ended up dropping one of…