🛠️ Enhanced Load-Bearing Industrial Hardware: Hardware Solution with 3-Section Extension for Drawer Slides Review

The soft close works for most, but sometimes the drawer does not close completely. Also, slides are generally extremely stiff to varying degrees. They're not easy to open and close, and they certainly don't work like other soft close slides I've purchased and installed for other apps. My expectations are to give the drawer enough push to close it up to the last few inches where the soft close kicks in, or even hold my hand on it and gently push down until the soft close kicks in . Instead…

I bought these drawer slides in December to use in a kitchen island I was building. A few months later I had my first slide failure. The bearings started to fall out and the box got stuck. I replaced it with a spare part. I'm glad I only needed 4 slides for the island. This left me with 4 separate foils as spare parts. About 4 weeks later another splint failed with the same problem. The bearing just started falling out, and then the box wouldn't close. I tried to fix putting the bearings back…

I bought a set of 6 22" rails. I had an issue with a manual which the seller was quick to replace for free without asking for a return. I also messed up another one when I put in the finished box. Drawer jams on insertion (immediately after the latch worked). I pressed it too hard (to try to get it in) and bent the first of the plates holding the ball bearing set. The clasp could be fixed but I decided to throw it away. I see that this could have been avoided if I had used an up and down…