Header banner
Revain logoHome Page
hhip 4006 0023 shank cutter holder logo

HHIP 4006 0023 Shank Cutter Holder Review

3

ยท

Very good

Revainrating 4.5 out of 5ย ย 
Ratingย 
4.7
๐Ÿ—„๏ธ Tool Holders, ๐Ÿ”ช Cutting Tools

View on AmazonView on ะฏM

Media

(4)
img 1 attached to HHIP 4006 0023 Shank Cutter Holder
img 2 attached to HHIP 4006 0023 Shank Cutter Holder
img 3 attached to HHIP 4006 0023 Shank Cutter Holder
img 4 attached to HHIP 4006 0023 Shank Cutter Holder

Description of HHIP 4006 0023 Shank Cutter Holder

Utilizes standard tool bits. Counter balanced. Made of durable, hardened steel. Head is 1.5". Takes 1/4" tool bits. 1/2"-13 drawbar end threads.

Reviews

Global ratings 3
  • 5
    2
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 4 out of 5

Haven't tried it yet, but the result leaves much to be desired.

What can I say assuming the R8 is shaped right it's nothing special. There are obvious sanding marks and the finish is pretty poor but it should work and for the price I wouldn't expect more.

Pros
  • Made from strong hardened steel
Cons
  • Not sure

Revainrating 5 out of 5

Solid, accurate, profitable.

Exactly what I needed. Stable with four set screws and the cone is tight even before it is screwed into the drawbar. Don't have the infinite patience to build your own ( I'm looking at you old Tony), grab this and some HSS footage and start cutting.

Pros
  • Drawbar End Thread 1/2"-13
Cons
  • Wrinkled

Revainrating 5 out of 5

Good milling cutter R8

Because of the thread on the shaft I wanted to deduct a star or two. They were wound diagonally and my turn would not start without trying to cross the thread. I was ready to return it but decided to have it repaired. Luckily I started threading right after beveling the end and got a good inch of thread so all is fine. The cutter itself is very good and holds a left-handed 3/8 cutter very well. It works flawlessly and makes a very smooth cut. The balance is very good at 900 rpm on my Grizzlyโ€ฆ

Pros
  • Counterweight
Cons
  • Not bad, but...