Furnace Control 🔥 Panel for All Systems Review

Perfect for my old oven. Pulled out the terminal jumper and changed the microswitch setting to match my Winchester propane stove's old faulty circuit board. Heat like a champion. Worked great.

Before installing I spent a couple of hours studying the old and new circuit boards and the installation guide. After fully understanding the procedure, it took about 45 minutes to uninstall the old one and install the new one. This board solved my problem (stuck fan relay). Now everything works great.

Good control board with very well written instructions. Read the instructions and you will understand how to set the DIP switches according to your specific oven. It took me about an hour to read the instructions and set the DIP switches, another hour to switch all the electrical connections to that control board and test the oven.

Excellent product. Installed on a Goodman/AC gas oven. It turned out that the problem wasn't with the old board, but the diagnostic codes on this board helped me isolate the problem very quickly - I kept the board even after removing the actual culprit (capacitor). The cost of this board is high - buying an OEM replacement board costs 2-3 times more and from vendors whose legitimacy was difficult to verify. There was some initial guesswork related to fitting some wires from my oven/AC where the

Very satisfied! I have an old oven that is in good condition but the electrical components are outdated. I'm tired of waking up in 50 degrees and running to a cold spider's basement in my boxers to cycle the circuit breaker a few times a week. Sign up for Honeywell. First let me say that if you come to this label maker party and read the manual twice, you will become a god. Johnson's old board had a hot and neutral section, photography and the launch of a label maker. I had a wire that didn't…

Latest update After reinstalling everything with the new board I found everything was working correctly and as expected. I am now satisfied with this product and have improved my overall rating. I can't in good conscience give 5 stars because I received a defective product and it ended up costing me more money than I could afford. Other than that, this is a good replacement for the Nordyne G6RA060C-12 that I replaced. Be sure to look at the DIP switch setting for this board to set up the board…

This circuit board replaced the obsolete York 031-01234-000 on the P2MPD14N08001C gas oven. The old board had a sticky relay that kept the ignition on by constantly pressing the right drawout switch. The swap was easy, basically find the settings for your board in the manual which includes setting up the recommended DIP switch settings and selecting the appropriate patch cords that come with the board. The box says this universal board replaces 195 different controllers, which is pretty…

This is a review of the Honeywell S9200U1000. I'm a tech-savvy homeowner who's been building my own computers from scratch for years, so I knew it was just a motherboard, and a pretty basic one at that. Installation was very easy as the harnesses touched most of the wires and I just marked each oven wire with tape so I knew where to route them on the S9200. The entire installation took 15 minutes and everything works perfectly. I'm in the Chicago area and the temperature dropped to 36 last…

I have ordered this Honeywell universal HSI replacement controller board to replace the York 031-01234-000 controller board. only stupid posts. The plastic base covers the entire copper side of the board (nice touch!) so it didn't matter as the board wasn't packaged in rigid styrofoam baffles. The panel was packaged in an anti-static foam bag. The shipping carton contained a clear plastic bag with connection adapter harnesses and a folded installation guide. First, a wire harness bag was placed