🖥️ inRobert DIY Dual Bearing 85mm 2pin Video Card Fan Replacement for Zotac GTX 1050 Ti Mini Graphic Card: Enhance Cooling Efficiency Review

I don't know how long this will last but my graphics card isn't making that horrible fan noise anymore. I used MSI's Afterburner utility to run the fan at full speed and it's still pretty damn quiet. Fits perfectly. Well, you'll have to cut off some of the little plastic thing holding the cord on the side because it's too long. There is also a small rubber stopper that you will need to pry out with needle nose pliers. This is a reasonable attitude. I don't think you can ruin everything. Buy it…

1. The power connector pins were not positioned correctly causing the power supply voltage to be reversed and the fan not spinning. It was possible to remove the pins from the plastic connector and reinsert them in the correct orientation as shown in Photo 2. This fan is thicker and has thicker blades (15.2mm for the hub) than the original (10.9mm) so it protrudes slightly from the airflow cover (about 2.8mm for the hub, about 1.5 mm for the wings) (see photo). ). Yes, my table doesn't fit…

. I had the right tools and experience to remove the crimp terminals from the housing and reseat them with the correct polarity so I did it. But I really didn't need to fix it if it was just about getting caught in quality control.

Had to snap off an extra small piece of plastic that the wires ran through, otherwise this fan was a direct replacement and was easy to replace. My GPU is now running 30 degrees cooler than the last fan, thanks a lot!