🔒 JQK Barrel Bolt Door Latch: Premium 304 Stainless Steel, 1.4mm Thick, 3 Inch Silver, Pack of 2 HBB100-P2 Review

Perfect Size. Seems strong enough for what I wanted. The item was received even though it doesn't show as delivered on Revain.

These are well made (stamped) barrel bolts. Very good price for a pair of stainless steel screws. Good quality. Why galvanize or galvanize when you can buy stainless steel at this price?

Worked as expected. Used outdoors so will be somewhat exposed to the elements. Loved the fact that it's stainless steel so I don't have to paint it. Perfect size for my unusual application. you will like it

They appear solid with a good finish, but the latch slides freely between positions. There are no locking tabs to hold the latch open or closed, so it cannot be used in a vertical position.

Great price but more than I expected. The quality is above average but there is no locking mechanism to allow them to open. I solved the problem by adding a long screw that sticks out to secure the clasp.

Good solid stainless steel fasteners. They don't have a stud holder, but that wasn't a requirement for me. The only downside was that the screws that came with it were tiny (e.g. size #6). They were stainless steel, but I replaced them with longer #8 screws.

The stainless steel cylinder lock is great, the original was completely covered with rust, the only complaint I have is that the thickness is too thin, but what do I use it because it works great and the price is right. I would buy it again for light use but am looking for a thicker block for heavy use.

JQK screws are well made all stainless steel slightly magnetic as they are 304 stainless steel As I use them around fresh water they should be fine. My only concern is that I mount them vertically (top and bottom of the doors and there is no latch stopper to hold them open. To solve this I need to drill additional holes in the mounting plates and install screws to as serve latches.Only buy this product if you install it horizontally!

Installed 3 of 4 bought. On the one hand, this bolt lock does not have the locking function typical of locks of this type. That means the lever doesn't move to one side, so the shutter doesn't slide back and forth. Second, the screws that come with it have a slightly larger head than the holes, so the screw heads don't sit flush with the lock when installed. The solution here is to make the holes a bit bigger. Third, the screws are too short. . . I think. On the other hand, a back plate curved…