Leviton 9864-LED 8.7W-120VAC 60Hz LED Ceiling Occupancy Sensor Lampholder - White Review

Excellent product. Used as general hallway lighting in an apartment building. Excellent motion coverage and brightness. Better buy than the same model with G-24 fluorescent lamp. Hopefully the LED will last, but I've used a fluorescent model and have averaged about 2 bulb changes per year per unit. These bulbs are specialty bulbs and range from $8 to $16 a bulb!

I bought two of these units. One for my wife's closet and one for me. Our cabinets are quite small, approximately 44" x 84" and 120" tall. Both lights were installed by professional electricians. Here are the pros and cons I've encountered. Pros: The light is bright. The motion sensor works well. but not higher than 84 inches. CON'S: The lights are expensive. For the price one would have expected more features. There is no motion sensor sensitivity adjustment knob/switch. There is no timer…

After my wife had changed my wife's closet chain lights countless times, I finally found something she couldn't wear out. The light is bright white and easy to install. The only complaint is that the included wire nuts aren't big enough for household wiring (12 gauge). Have it ready before you start the installation. I plan to replace every lamp in a closet in two houses with this solid-state device.

Looks cool but if it works (hadn't fitted mine yet) I'm happy except for the price which I currently think is very very high of the options LED Lighting. I chose this because the manufacturer has a reputation for quality and because it was exactly what I needed, even though the style didn't suit me. Again, I accept this with its shortcomings because I feel it will fill the need.

Can't put a wall switch in a closet without losing the string of lights? In fact, you use what appeared immediately after the discovery of electricity. I hooked them up to three cabinets and what? a. Difference. The lights are bright enough for any shared closet, they turn on automatically (when motion is detected) and turn off after 3 minutes (good for those of you with family members with limited use of the switch) and they are therefore LED They don't actually use a lot of electricity…

This motion activated LED light is super easy to install if you're even a little familiar with electricity - just make sure you unplug the power connector from the installation point panel (not just from the wall switch!). Once connected and installed, this little device turns on automatically when it detects nearby motion. The motion detection works perfectly. It stays on until about 3 minutes pass without motion detection, after which it turns off automatically. The light is bright enough for