🗄️ Innovative Liberty D80622C 22 Inch Bearing Drawer for Organized Storage Review

I bought this kit as a replacement bathroom door for my 2015 Arctic Fox 811 Truck Camper. This set is an excellent replacement in more ways than one, in my opinion. First of all, it fits snugly, although I had to drill pilot holes and reposition the screws on the doors. It's ok, the valve itself is completely silent when opening and closing the door. When the door is closed, the latch "locks" to prevent accidental opening of the door. You must physically open the door. Another great feature…

I'm still having trouble installing. After reading the instructions I realized I needed an extra part. "For frameless cabinets. A set of sockets D806 is required for front cabinets." This was not mentioned on the website. Now I'm a do-it-yourselfer and not sure about the difference between a frameless or front cabinet. I have kitchen cabinets with a drawer that doesn't slide out easily. To make it even more difficult, if you are looking for a D806, Liberty D806 or Liberty D806 socket set, the…

I installed them in a friend's kitchen where her old build quality drawer slides were not round, were difficult to open and only opened about halfway securely before they felt like they would stray and break. Floor. They were a disaster waiting in the wings. The new rails really slide under the same weight as before, and the drawers open fully so she can see and access items at the very back. The installation instructions are rather sparse and there is a lack of troubleshooting information. One

I have bezel cabinets and was concerned I would have to order a separate accessory to install them. The included instructions specifically state that they are for frameless cabinets. However, for me they are perfectly installed without the need for additional accessories. I simply screwed the side rails to the inside walls of the cabinets and the rails to the drawers and it all went smoothly. I like the full extension of these slides as I have multiple drawers with items that were previously…

As long as you follow the instructions (I didn't do the first half of the install oh!) the drawer slides slide in very easily. They are also very strong. I actually only installed the front and middle screws (the back ones are very difficult to get to) and the drawer doesn't flex at all when fully extended unless I lean in. I would say the drawer can easily hold 10 pounds or more. Some suggestions/recommendations: 1. Get a tool to hold your slides; They are difficult to hold with one hand and…

The race in the old slides in the center drawer of my office desk broke after thirty years. I didn't get too upset because the old ones weren't fully stripped and it was very difficult to get to things at the very back of my drawer. I really like her. They have a tight seal so the box does not crack, it opens easily. They are smooth enough and just as smooth as the ones I replaced. However, I have used drawer slides which were a bit slimmer but cost 5 times as much so I won't turn them down…