🔧 Crimped Diameter: Lincoln Electric KH321 - A Powerful Solution for Precise Crimping Review

Please note this is a made in China assembly. I had a spoked wheel of the same model and name as this one and used it for 15 years, only occasionally throwing the wire out of the wheel. This new one ejects the wire during free spins on my grinder without actually pushing any material against it. I don't expect it to last 2 years let alone 15 like my old one.

If you do a lot of wire wheel work on a bench grinder, I highly recommend this wheel. I used to have a regular spoked wheel. Trust me it was maybe 1/2 inch thick. This wheel is one inch thick. It works way better. Some have had thickness issues when fitted to their bench grinder. Problem. I also had to use some large shims instead of the shims typically used on thinner wheels. The washers didn't leave enough room on the shaft to fit the nut. After replacing them with some washers there was…

The width of this circle is as shown. It should be noted that due to the fact that the bristles of a wire brush are not quite vertical, but protrude slightly outwards, you have to expect more width. Approximately 1 3/8" wide at the outside diameter of the shaft. Take the time to check if there is room for your grinder before purchasing as I was too lazy to get up and do so before ordering. This product seems too wide for a 6" center grinder from Harbor Freight. Enough to stop the engine all…