Linkstyle 48-LED Interior Light Bar With DIY Switch - 6500K White LED Strip For Car, Truck, Camper, RV, Boat, And Cabinet - Pack Of 4 For Enclosed Trailer And Cargo Lorry Lighting Review

They are a little light weight and flexible. I was expecting them to be a bit more rigid. They also come with some kind of magnet system that doesn’t seem usable but we installed directly into the trailer. They do not pull hardly any power so it keeps them from flickering and they do light up the space well. For the price you can’t complain.

Great bright lights, I mounted these in the rear of an SUV to provide additional lighting of the trunk area. They work great, but the very small amount of plastic where the screws must pass, required a trip to the hardware store to find screws with a small enough head to mount them without damaging the body of the light.

I installed 4 of these into my 32' enclosed trailer. I wired them so that I can either use my truck or a 20v dewalt battery to power them. So far they are working great. (Installed 1-26-2022) I will update this if I have any issues. The 1st photo is the factory trailer light, 2nd is only the 4 new lights and 3rd is both together. These are spaced about every 6'. The mounting brackets could be a little more solid but so far they are working great. I have a 750 mile trip in a few weeks so we will

Provides great light as a replacement for fluorescent lights in motorhome. Easy to install with screws, brackets or tape. Purchased 6 packages, 24 lamps. Two lamps were defective, one total short, one a section of leds not on. Hassle trying for replacement since package contains four and only two were defective. Finally accepted Walmart account credit.

These lights did exactly what I needed them to do. shine the inside of my 7x16' enclosed trailer. I tied in the lights with one of the existing interior lights that were already inside of the trailer. The red wire from the light switch is the positive and the black is the ground. I grounded them right to the crossmembers for the roof with self tapping screws, so that also means I had to add eyelet connectors to the end of the wiring (no big deal). All in all, these lights are pretty dang bright

I'm using them to light my barn with 12v solar and they work great. The feature I like most is the mount brackets are magnetic. So I mounted them on Simpson tie brackets so if I need to move them at some point I just move the bracket, also I stuck one on a garage door rail. The only negative is the mount holes on the ends are worthless as the switch and wires interfere with the mount screw hole but the clip on brackets make up for that problem.

I like these lights because they're lightweight and easy to install. I don't like these lights because they're not very bright. I have a 12 ft. by 20 ft. Tuff Shed. I installed the four lights only to discover they're not as bright as I thought they would be. I guess, though, for the money, they're okay.A day later.I checked again last night in total darkness. When I flipped the switch the lights surprised me. They were plenty bright. So, for the price, they're great.

Bought to replace two interior dome lights for my enclosed trailer. Worked very well and was happy with completed project.Installation included three options, double sided tape, metal brackets that clip onto the light bar and magnets. I did not use the magnets fearing they wouldn’t hold up to the rough ride of a trailer (plus one magnet was missing the magnetic part). I thought about using the metal brackets but the screw provided was tiny and had minimal about of thread to hold so figured that

made of aluminum so using simple magnets won't work unless you glue the magnets to the back. That is the tricky part. It comes with clip on magnets that are pretty poor quality. Installed in my sand blast cabinet and 3 give enough light for my small cabinet. Add more if you need them. Mounting screws would not work here but may work great for your project

Having a reliable light in the head's sink area has made all the difference in the world! There is an on/off switch built into the light bar already, but it is cheap plastic, so I put a toggle switch in the circuit anyway (on the left). Bear in mind that is light bar must be mounted to something or you'll have to glue the end caps on.

Product is cheap made. Lights do not have the on and off switch in the end of the light as described. Screws are cheap pot metal and will not stand any preasure from a screwdriver. Over all I'm very disappointed in this product and I'm going to have to figure out way to use them

Purchased 6 light bars and 4 worked? The ones that are working look great, test each light before installing! Thanks for attention!

Each light has a small spring steel bracket that mounts to my trailers ceiling crossbar. The light inside is excellent now. Very easy to mount-no short term issues.

2 of the 4 were non-functional out of the box. Walmart is sending a replacement set and I'm sending these back. This just shows the quality of the item is not really there.

Easy remedy for dark interior of trailer. The screw tab by switch should be longer. Screw head can interfere with switch operation.

The new light in my RV is awesome. Thanks for attention. We have had a yellow looking light for many years but this solved the problem