Magnetic Bit Holder Extension Construction Review

Bought this set despite other reviews saying the extensions were crooked. Decided to try my luck. Yes, they are wrong. Giving 3 stars because only one was really bad, which is interesting, it was the short 2 inches that sucks the most and crooked as politicians. The long 6 inch extension was surprisingly "ok" and the average 4 inch piece would work even though it was crooked. For my needs. Keep in mind I didn't buy them for power drive, just a small titanium micro ratchet. So for my needs I…

Average quality at best. Probably because it's made in China. The lifetime warranty requires you to ship the item back to Illinois at your own expense, making shipping more expensive than it's worth. It's a pretty safe bet if you offer a product warranty that's cheaper to throw away and buy a new one than to send them back for a possible replacement and hope they don't opt for a repair, replacement or refusal clause at discretion. Like most Chinese-made products, it's not really a lifetime…

I ordered these a few months ago and wish I had fully tested them sooner because if I did I would return them in a heartbeat. I used to use various 1/4" bits to drive in and remove 1/4" hex Tapcon screws and finally got around to getting the plywood from one of last year's hurricanes. The 2" nozzle fell off after less than a dozen screws! I was glad I didn't collect plywood when I was hit by a category 4 or 5 hurricane while testing! A few days later I had to use a Phillips screwdriver. The 2"…