🚗 Pair of Mean Mug Auto Front Windshield Washer Nozzles (61518-232314B) - Fits Ford Vehicles - Replaces OEM #: BC3Z-17603-A Review

After installing and testing the spray I noticed that I was not getting an even spray, it was more of a one sided spray than an even spray across my entire windshield.

This is not a universal kit you can get from an auto parts store (which will not normally fit). It is exactly the same as what came with the car from Ford. Fits perfectly. Clicks immediately. Installation took less than a minute

This item works well and is easy to install as it should be. It appears to be a little higher than the stock part on the other side and the wiper water target is a little higher, but that's not a problem. [2015 F350]. It's been installed for a while, but I can't say if it will last longer than stock.

There are two problems with these injectors. 1. They do not match the spray pattern. One sprays in one direction and the other fully in the other. 2. They break so easily. The photo above shows mine broke after just a month. I hate spending extra money on a Ford OEM jet, but at least they last a little longer.

I received the package today, a day earlier than originally stated. Installs in a minute or less. And it stays the same as my original. If I didn't know better. I would assume it is OEM as the finish and nozzle are perfect. For those who have problems with the spray. I would advise you to check and make sure you have removed any defective parts from the hose. It happened on a 2012 Ford F-350.

One of the original attachments broke so I bought them. I just replaced the broken one and kept another original atomizer instead of replacing a pair. The replacement part broke after 3 months. I replaced the broken one with the remaining Mean Mug and it broke too. So both Mean Mug tips are broken, and one of the remaining original ones is still hanging there. Maybe that side of the hood gets more heat from the engine, but I'll try the original Ford OEM.

Mainstream Splashes onto Windshield. Ford super dut 2015 The injectors went straight into the holes in the hood. I did as a reviewer suggested and used a heat gun to heat the nipple and rubber hose prior to installation as it was 30 degrees this morning. When I activated the atomizer, I was disappointed to see the main jet pouring down the top of the windshield. I'm pretty sure it will work fine when you're driving, but if you're standing still and trying to clean your windshield it's going to…

Powered by 2012 F250 Super Duty. Ironically, Advance Auto has stated that they can't even order them. Both of our original washer nozzles broke on the plastic hose under the hood, directing the wiper fluid to the engine. On this car, the injectors are located closer to the center of the hood. They fit perfectly. When installing new injectors, be sure to clean dirt from the rubber boot they connect to. For one, I suspect a piece of plastic from the old nozzle's nipple was still in the line and…