🔍 Contractor Pressure Gauge - Measureman Stainless Steel, 0 to 100 PSI Review

I needed to replace the pressure switch on my compressor and the gauge on it is a bit worn. The original was 2 inches at best and had multiple scales, of which I really only need one: PSI. Not only is it nice and big, it's the only scale I need! I don't have to look for my glasses. I had to install them with NPT > Flare > NPT with a piece of copper tubing in between to suit my application, but depending on where you place your goggles you may not need to do this. what is there at a…

I needed a new pressure gauge for my pool filter. Those sold by pool manufacturers are cheap and difficult to read. After looking around a bit I found that this is almost what I need. I say "almost" because that's what I use in the pool - the pressure ranges from 10 to 30psi. Rarely more. Unfortunately, the scale of this item is 0 to 100, which means the usable portion of the scale is tiny for my application. I wish this company would make the exact same item with a pool friendly scale, say 0…

Excellent support from MEASUREMAN. Although a special tool may be required to remove a depressed pointer, changing the scale dial isn't too difficult. The difficulty lies in recalibrating when reinstalling the dial hand. In my case, I first used a pressure regulator to apply half the pressure scale to two gauges simultaneously. I later repeated the same exercise to adjust the dial needle to point halfway through the pressure scale when reinstalling. As an added benefit, it became clear that two