🔧 Meihejia Bottom Bearing Pattern Router Review

I make custom furniture for a living and if you do a lot of milling there are always two paths to take. Spend a lot of money on super expensive beats and get very upset when you drop them on the floor and they shatter. Or you can buy cheaper beats, use and abuse them and you will be fine. They worked well for what I use them for and when they arrived they were well packaged and everything worked fine. I will continue to buy these beats.

I didn't expect this to be a premium quality tool for the price I paid but I did expect it to be good for the one project, the I need it for. . Instead, what I got wasn't sharp at all, which I quickly discovered while making the cut as he grabbed the lock blank, yanking it out of my hand and almost snapping my hand into the blade. Luckily I wasn't hurt, but it did destroy the $50 CNC jig I got, the $25 piece of exotic wood, and a perfectly good pair of panties. That $17 beat cost me $75 in…

I have only used a ¼ inch bit so far and I don't think I used this bit for a total of 15 minutes before the bottom bearing simply broke during use. I've only used this bit for trimming plastic laminate and making a few small ¼ inch MDF cuts before the bearing fails. The lowest durability rating I could give this bit was a one, but if I could give half a star I'd put it in. I'll swap out the bearing and keep using this attachment, but it broke pretty quickly.. I have Wasn't expecting anything…