🏍️ PC Motocross CG250 Intake Manifold Pipe with 30MM Carburetor - Compatible with CG 200-250cc ATV Dirt Bike - JQ120 250cc Carburetor ATV Intake Pipe and Carburetor Accessory Review

is screwed on but that's it. This places the carb in the wrong place and hits the frame, and the cab moves sideways no matter how you try to bolt it on

Ideal for 150cc Hawk/Viper CG carb upgrade to 30mm instead of the standard 27mm inlet, defeating the purpose of the upgrade and making one Manila seal required.

My original rubber boot ripped. The motorcycle did not become an idol. Found a very small crack, switched to this cast. and damn it, the bike won't start, run or swing. This takes the worries out of rubber products. Since this is an air-cooled bike, heat destroys cheap rubber parts. that was the solution.

I bought this for my Rps Hawk 250 to replace a cracked stock header. Does not work with airbox. The intake manifold changes the orientation of the carburetor to straight back. So if you have a Hawk and are looking at it, buy a 44mm uni or pod filter to match your carburetor and you're good to go.