📺 Mount-It! RV TV Mount: Lockable, Full Motion Wall Mount for RVs - Single Arm, 42 Inches Max, VESA 200, 33 Lb Capacity Review

Great mount for 24" flat screen TV at home. I installed it on a very thin wooden wall covered with fiberglass on each side using 2 wall panels, one on each side of the wall. I had to purchase a separate set of nuts and bolts for this custom mount. Sure you'll have to look at the second mounting plate on the other side of the wall, but the TV is solid enough and we're happy with the quality of the product, including the locking tabs that keep the TV in place when travelling. .

This mount is very strong when tightly adjusted. If you use it to put the TV in one position and don't need to move it, then everything is fine. Repositioning is very fiddly though - there are three different adjustment screws, one at each pivot point, which are difficult to tighten and loosen by hand. If they're loose enough to change the position of the bracket, it's very loose and loose - they need to be fully tightened to use the TV. If you e.g. For example, if you often have to change the…

I bought a smaller mount to use with the 24 inch TV in my truck. Installation was fairly easy and the instructions were fine. The equipment supplied is not intended for use in a van. So we started looking for different mounting screws. My first signs of a problem came after everything was installed and I'd been driving for about 4 hours. I kept hearing something rattling in the bunk. It was a swinging TV. One of the set screws loosened and almost fell out. The next day the same. In the next…

. It comes with so many fasteners that you will have no trouble finding the right combination for your installation site. I installed 32" and 24" TVs in my trailer and each one took me about 20 minutes. The 32 inch arm has some flex but not enough to be concerned. The TV is a bit warped in the fully closed position, but when you move it to the viewing position it fits perfectly. The design makes it easy to take this TV down for travel and put it back together in about a minute. This is a great…

This is a solid TV mount that allows for more portability if that's what you're after, but this is definitely the standard RV mount advertised becomes. The mounting hardware provided was intended for a solid 2 x 4 stud wall as the screws provided were longer than the RV wall. I swapped them out for others so as not to spoil the look of my van. I originally bought this mount because the base has a slip so I can detach the tv when traveling and use the same tv for outdoor mounting. The biggest…

You can purchase a second base. Surprisingly, in the end, 2 bases turned out. I was very happy with it. This is a great small TV or computer monitor mount for my RV. My camper came with detachable monitor mounts but no pan and tilt. I removed the old mounts and replaced them with the ones in this kit and now I can tilt the monitor to my liking. ADVANTAGES: * After installation, the bracket is fixed with thumbscrews. * In travel mode you don't need to remove the monitor as others have stated…

I bought 2 sets of this TV mount for my Class C RV with a 32 inch TV. I originally had hanging closets with an entertainment center and converted them into a hanging bed. As you can see from the box layout picture, I added a third hand to give me enough reach (beware, this is probably not recommended by the manufacturer). The TV weighs about 13 pounds and we don't use it when we travel. It works great for turning and stacking against the side wall. As already mentioned, tightening the grips is…