Partsam Rectangle Reflectors Accessories Rectangular Review

Looks great and hope to have many years to come. The only negative (if negative) is that somewhere in the description it says polarity doesn't matter for these - IT DOES. When connecting and before screwing, be sure to check each of them. Also a great tip from RVin with Tito (Brian) on YouTube is to use a small piece of Eternabond over the hole in the RV to improve waterproofing.

I installed these on my caravan in 2016 to replace old bulbs. They all worked fine until the end of 2017, then in 2018 I noticed that a few bulbs had burnt out a few LEDs. I hooked up a trailer for the first time this year and 5 out of 8 lights have at least 50% of the LEDs off. If you are planning on installing these lights on a trailer that you will be using for any length of time I would recommend looking elsewhere.

These were direct replacement bulbs for the bulbs in my RV. Easy wiring and uses the same holes. The only problem I had was that after installing them all and waiting until dark to admire my hands-on work, I found that they weren't all the same brightness. Of the 5 red lights at the top of the back of my camper, 2 are noticeably dimmer than the other 3. Slightly disappointing but I already covered them in silicone so I told them to forget about it and left them there.

I bought these to replace broken headlights on my 2006 Four Winds 5000 motorhome. I have to say that the design of these lights is much better than the factory lights. The old lanterns were cracked and it was not possible to replace just the lenses and the screws were exposed to the elements. The good thing about these new lights is that the screws are behind the lens itself. If the lens is broken, it would be easy to replace. I have ordered the correct RV silicone and am waiting for it to…

Looks great compared to the old bulbs. It would be better if the wires came out of the hole at the back closer to the headlight, ie it would be easier to install the headlights completely flush with the motorhome's surface. I managed to fix the situation by rerouting the wires a bit. Also, double-sided, double-thickness Eternabond is recommended for sealing fixtures instead of sealant or lap sealant. Once the light is drawn to the eternal connection, no rain falls there. That looks very cool…

I bought this kit to replace all the marker lights on my 2006 trailer. I would say they are just as bright as the originals. I replaced all of the interior lights in the trailer with LEDs to reduce battery drain and since I didn't have two bulbs I replaced them all as well. It took most of the day to move the 8ft stairs, but now they look a lot cleaner. You need to connect them with the correct polarity, and in my case the old blocks' holes matched these new ones exactly. So after cleaning all…

UPDATE: Three lamps failed after three years. They dim and then stop working. In addition, plastic housings are destroyed by UV radiation. Typically, LED bulbs last for years. They begin to fail after three years and a very limited on-time while the van is in motion. The headlights installed by my trailer builder were poorly designed and incandescent. Lens caps often fell off. I ordered seven red and five amber bulbs in this kit, replacing the originals. The lenses snap firmly in place and…