Header banner
Revain logoHome Page
🎨 colored acrylic plastic pieces with engraving logo

🎨 Colored Acrylic Plastic Pieces with Engraving Review

3

Β·

Average

Revainrating 3.5 out of 5Β Β 
RatingΒ 
3.3
πŸ›οΈ Plastics, 🌾 Raw Materials

View on AmazonView on Π―M

Media

(4)
img 1 attached to 🎨 Colored Acrylic Plastic Pieces with Engraving
img 2 attached to 🎨 Colored Acrylic Plastic Pieces with Engraving
img 3 attached to 🎨 Colored Acrylic Plastic Pieces with Engraving
img 4 attached to 🎨 Colored Acrylic Plastic Pieces with Engraving

Description of 🎨 Colored Acrylic Plastic Pieces with Engraving

Colors:Ten colors mix and match of rainbow colors. Packing:both sides covered with kraft paper or PET film, then pallet. Size: 12"Γ—20β€œ ( 30.5 cm Γ— 50.5 cm ). The acrylic sheet is no-translucent. Comparable to plexiglass, cast acrylic is a lightweight, rigid plastic that resists breakage better than glass and offers excellent weather resistance. Easy to Cut and High-Quality Cell Cast Design – With no melting point, cutting through our thick acrylic boards with a laser, tablesaw, jigsaw, drill, router, or bandsaw is quick and easy. The cell cast version offers clean cut edges without burrs, sharper laser engraving, higher resistance to scratch and chemical solvents.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    1
  • 2
    1
  • 1
    0

Type of review

Revainrating 3 out of 5

Product is fine but shorter than advertised

I ordered 12" x 20" sheets but the sheets are about 19" so I'm about 0.5" smaller than the project , for which I bought them. The leaves themselves are fine and cut well with my CO2 laser. The colors are beautiful and as described.

Pros
  • Plastic
Cons
  • Something else

Revainrating 5 out of 5

Whole Lotta Acrylic

I have these for my laser cutter. Buying them in bulk has saved me quite a bit compared to buying them individually. The edges of the panel are a little rough, cut with a saw rather than a laser, but that's fine if you want to cut something anyway. The plastic and paper backing on both sides peels off fairly easily when you cut it, but you can poke the corner a bit with your fingernail to start peeling. Aside from the capital investment and the driver's annoyance at how heavy they are because…

Pros
  • Industrial & Scientific
Cons
  • Not sure