💥 Enhance Bass Demand with Planet Audio PCBLK2.0 - 2 Farad Car Capacitor for Enhanced Energy Storage Review

This 2 farad cap is probably the coolest cap I've ever bought. It was easy to install and the digital display is very clean and clear and it flashes blue when you turn on the amp. I have no static, no problems, everything works great, I would recommend it to anyone who has installed an amp up to 2000 watts.

I DON'T THINK THIS WILL HELP YOUR SYSTEM AT ALL? I HAVE AN 05 F150 C KICKER KX 2400:1 AMP SERIES TRUCK CONNECTED TO 2 12" SKAR AUIDO SUBSUBS ALONG WITH A SECOND N BASS RESTORATION RCA BATTERY AND I CAN WATCH THE VOLTAGE DROPS BELOW AS 10 IT SWITCHES TOO THE HEADLIGHTS OUT It was before I got it it's really a joke and a total waste of money in my case because it didn't help me at all I HAD A TRUCONNECX 1.0 FARAD WHICH HELPED MORE THAN THAT 10 FARAD IT IS SAD.

Definitely not a 10farad cap, it really helps when the electrical system is stressed. However, it works about as well as an old-style 1 farad capacitor. It's very visually appealing and should theoretically prevent the headlights from dimming. My headlights are still dim, "not that strong," but still noticeable. I only use a 200dsm punch for a 10 inch subwoofer. The Punch 200 is a very underrated and class A/B amp, so actual power output is probably around 700 watts pure. All in all a good…

Use as short term power supply for Raspberry Pi to handle power shutdown. You can use split ring pliers to remove the power and alarm board from the top. This greatly reduces leakage from the cap. Without this, the capacitor self-discharges 0.01V every 1-2 seconds. If the card is not removed, it will drop 0.1V every few seconds. I'm using a 5V buck converter to power the Pi. I get 15 seconds of runtime from 12V before the Pi drops voltage and shuts down. This gives me enough time to complete my

In general everything is fine. Had problems with charging because disconnected the remote cable from the main unit, connected resistor and no digital display backlight, left for about 5 minutes, went back and connected the positive cable directly, then connected the remote and everything was fine. Normal operation 13.5 volts without amplifier operation 12.4 volt operation with full amplifier power. Have 1 Pioneer d-series monoblock pushing 2 12" Pioneer 350 rms. It originally didn't have light…

I want to give this product 0 stars. Got my first capacitor. The charging instructions didn't work, but I work with electronics so I charged it correctly with a test lamp anyway. It had no capacitance and would drop below 12 volts on bass kicks and feed a relatively small 500 watt amplifier. I contacted the company for an RMA on February 11th. I didn't get a replacement until March 2nd (in fact they didn't even send my replacement until February 24th when I contact them again to ask where it…

Take your time and use a good quality power and ground wire, such as a high quality cord. B. Sky High Audio OFC 4 GAUGE wire for power and ground. Great wire, don't be shy, VERY flexible, but always get 25% more length no matter what wire you use, I think that's enough! The condenser was well packaged in Planet Audios. THE MANUFACTURER'S PACK WITH NO FOAM INSIDE JUST AN CHEAP PLASTIC MODEL FIXED WITH WIRE TIES IN THE CONDENSER BOX! MADE ME NERVOUS, especially the electrical part! Tries. I've…