🏋️ Pro Series EA20000303 A-Frame Jack: Best-in-Class Performance in Sleek Black Finish Review

I bought two of these to stabilize a Toyota pickup trailer with a crane. Considering the loads the crane can lift, I NEED to stabilize the trailer. Good work! See attached photo

Used to replace my electric jack which has become dusty. Not a bad price. Screwed immediately, without changes. Used on a 33ft RV. And the only thing I see is that the mechanism will hit my propane system. But it's better to use a bottle jack.

Exact replacement for the irreparably damaged original jack. Fits perfectly. The quality appears to be better than the original that was on our trailer. Took less than 15 min. Remove the old bushing and install this new one.

Perfect for my single axle cargo trailer. Make sure the replacement you choose has the right load range as your trailer and you're good to go. It doesn't come with a wheel or skid plate so keep that in mind because I don't like sticking the jack tube in the dirt! Hope that helps.

Bought as an exact replacement for my closed LOOK trailer. My original jack still worked perfectly, but someone borrowed my trailer and damaged it. While driving on the road, the trailer broke off the ball and landed on the underside of the jack, where I was unable to use the stand. This jack appears to be the same model, including the weight limit. The installation took about 5-10 minutes, the jack is screwed with only three screws.

I replaced an aging jack on my caravan with this model. What a huge difference. I can lift and lower thousands of pounds with one finger. I'm not sure what the problem is with my old jack, maybe it had some kind of internal rust that made it uncomfortable to work with. This jack does not have a leg and I would recommend that you purchase one (wheeled or fixed) so that the round end does not bend or deform.

This is a replacement for a jack that someone fitted to a used trailer I bought. The jack is fine and the height was spot on when fully retracted BUT I use a jiffy stand on this trailer, not a wheel, and the bolting position turned the jiffy stand sideways for me. On the whole it doesn't matter, but be aware that the bolt pattern leaves a solid rectangular foot perpendicular to the trailer, not in the direction of travel.

*WARNING - CHECK THE SIZE OF THE HOLE ON THE TRAILER* (review below - read the caution first) I ordered this jack because the current jack bent when it went on a hike on the rim a pothole in a low road. I've had several trailers with different types of jacks and this one is just as good as mine. Absolutely great jack for the price BUT MAKE SURE you check/measure the frame hole diameter before ordering. The body tube on this jack is approximately 2-1/4 inch (or 2.25) outside diameter (OD) while…