🏎️ Optimize Performance with Racing Power Company R2083 Throttle Return Spring Kit Review

excellent product, I wish everyone a screw where stainless steel or chrome is a mixture of screw types. No Allen key. The springs are difficult to install but the looks are great, just what I was looking for

I used this on a Demon 650. It required a small modification to prevent it from contacting the accelerator pump lever. Well made but with lots of options for how much reflecting power you want.

Fits snugly and works great on the Holley Sniper Launcher. I had to modify the carburetor fitting, but that was out of laziness and because I didn't want to buy a longer bolt so I could mount the spring retainer. Light Feathers with Sniper was the perfect combination. I will be buying another one soon for another build with Holley Carb.

The large hole that goes over the carburetor stud has been misaligned. My impression is that most of them probably do, but there is poor quality control. Expanded the hole with a drill, the metal is soft. When I put it on the stud, the other smaller hole didn't line up with the hole in the carburetor. I was about to expand this as well when I noticed that the hex bolt intended for the second hole was too long to fit in the hole due to the connection above the hole. The screw should be about…

I ordered this while trying to clean the throttle body on my Ford 351W, Edelbrock intake, Autolite 4100 carburetor Can't work with my carburetor. The holes in the bracket that are secured with carburetor bolts do not match this particular carburetor. However, I believe it can be made to work (and will try to work on it more over the next few weekends). The accelerator pump linkage on this carb will interfere with the recoil spring mount a bit, but may be fine once connected. to the carburetor…