🚁 RCGEEK DJI Mavic Mini 2/Mavic Air 2 2S/Mavic 2 Pro/Zoom Spark Drone Remote Controller Tablet Mount Extender Holder 10 inch - Grey | Compatible with Crystal Sky Monitor | Lanyard Included Review

I liked this product but beware; You need to design a product for this item to block the light. Difficult to use when there is too much sunlight. I fully understand that when using the drone in the sunlight (phones) the display/visibility will be affected by any light and the type of mount you use doesn't matter. That's why I'm asking (is there sunscreen) about this product. ?

I have a Samsung Galaxy Tab 6 with a slim but strong body that I use for home and roof inspections with a drone. When using this tablet holder, I have to tighten the connections with an Allen wrench just enough so they don't collapse in flight. It's compact if you're using a smaller, lighter tablet, in which case it fits snugly around your joints. It just means I can never fold the mount if I want it to stay in the right position for my tablet. If it was a little stronger without the tool it…

. I don't see the slightest possibility that this device can support a 10 inch iPad. I just tried my iPad Mini 5 and it was loose enough that I was afraid my new mini would fall on the floor. The cam arms (which are smaller than the photos) are as tight as I could get and they still move a bit, but the bottom pivot with a hex bolt on one side and a nut on the other doesn't come to mind at all tightening it up because the bushings won't fit in the little recessed hole that the nut sits in…

The bottom pivot closest to the controller can't support the weight of the new iPad 7th Gen. While the rest of the adjustable pivot points can be hand-tightened with the available lever, the bottom lever isn't - it can only be tightened with a hex wrench, and the rear nut (probably 7mm) is difficult to reach. with socket, depending on available tools. I own and have tried a variety of outlets; Either the socket is too wide to fit in the recess that the nut sits in, or I couldn't find a metric…

I'm old and don't see so well anymore. I needed a bigger screen to see where I was going instead of this tiny screen on my phone. The iPad mini was the perfect size and seems to fit my Mavic 2 Zoom controller. It works, but there are some features of this holder that indicate it was designed by an engineer who never used this product. First, these are the turnbuckles for adjusting the angle of the handles. You are backward. That is, to tighten them, I have to turn counterclockwise, which is not