🔌 Red Hound Auto Toyota Power Outlet Socket Caps - Compatible with Sienna, Sequoia, Tundra, Venza - 2-pack of Cigarette Lighter Plugs (2004-2010 Sienna, 2008-2014 Sequoia, 2007-2013 Tundra, 2012-2014 Venza) Review

I was hoping to find this for my Toyota Sienna as my socket broke and was loose for a while. It was a great relief for me to finally be able to find the right size plugs that fit and hold in place. Highly recommended!

The Sienna 2010 has two sockets in the front. It turns out they are different sizes. This kit replaced the right one, but was much smaller than the left one. I would rather buy two different sizes to match if there is any indication that this is a requirement. For one, it was the right size. It can get 5 runs as it is well installed and works well.

Please note: If you need to replace both power connector covers, this set is not for you. Our 2008 Sienna is showing its age and wear and tear as a family van. Both driver power connectors were broken and I was happy to find this pair which looked like a replacement. Both fit perfectly in the right port, however the left port (closest to the driver) is slightly larger. They're too small to keep in this haven, so having two in a pack isn't very useful.

Identical to OEM part. For my 2007 Toyota Sienna, the installation involved removing the old metal part of the cigarette lighter from the dead holder through two small plastic tabs inside the metal can, opening the storage compartment under the outlets, and pulling out the console trim. You can then install a new plastic holder in the hole in the console, stick a metal lighter through the holder (it has a key), and then plug in the electrical thing on the back of the console. Then insert the…

I ordered a pair of these caps in part because some reviewers claimed they were OEM quality but that is not the case. I was sure I saw a blink in a product video and I was. Skins are thin edges of plastic that squeeze through slots in the mold used to form the product. This indicates poor form and lack of post-processing. It flickers at these sockets. The hinge action of the cap is uneven and doesn't have as much friction as an OEM cap, allowing the cap to fall off instead of staying open like…